3.0ranger1227
New Member
- Joined
- Apr 20, 2009
- Messages
- 998
- Reaction score
- 11
- Points
- 0
- Vehicle Year
- 2003
- Make / Model
- Ford
- Engine Size
- 3.0L
- Transmission
- Automatic
Anyone done aluminum center consoles in their trucks? I'm going to try and build one when I swap motors, mainly to hold the shifter. What i really want to see is how you did it. I was thinking press brake to make the bends for the sides, beads for stiffness, etc. But some pictures I've seen had fairly wide bends along curves, and obviously these were not done on a brake.
I was thinking start it at the stock floor cupholders, go up to the shifter height, and then back down to disappear under the middle seat. Anyone think this won't work?
I was thinking start it at the stock floor cupholders, go up to the shifter height, and then back down to disappear under the middle seat. Anyone think this won't work?