• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Clunking in front end


rnewkirk

New Member
Joined
Feb 5, 2023
Messages
1
Reaction score
1
Points
1
Location
Wilson, NC
Vehicle Year
2000
Make / Model
Ranger XLT 4x4
Transmission
Automatic
Clunking noise in front end when moving at any speed. I removed the driveshaft and it still does it, so I know it's not the cv joint. I jacked up each front wheel individually and can turn the wheel about 1/4 turn and it gets in a bind. Does it with both sides.
 


dvdswan

Well-Known Member
U.S. Military - Veteran
Joined
Feb 11, 2021
Messages
2,835
Reaction score
2,904
Points
113
Location
Seattle, WA
Vehicle Year
1991
Make / Model
Ranger XLT 2WD
Engine Type
3.0 V6
Transmission
Automatic
2WD / 4WD
2WD
My credo
Keep your mind like an umbrella, it only works if its open... Continually learning.
Welcome to the site.

The hubs maybe stuck in the lock position. I would check the boots to see if they are torn. Then grab the axle shaft and see if it moves in any direction other than turning.
 

Sponsored Ad


Sponsored Ad

Staff online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top