Patrologia
New Member
- Joined
- Aug 16, 2019
- Messages
- 18
- Reaction score
- 5
- Points
- 3
- Location
- Milwaukee
- Vehicle Year
- 2004
- Make / Model
- 3.0L Edge
- Transmission
- Manual
I’m working on the rear brakes on my ‘04 Edge 4WD. The right side was pretty toasted: wheel cylinder shot, brake line itself pretty rusty, etc.
Long story short, I’ve replaced the line with Ni-Cop, but the bracket that anchored the original line is gone. Total rust, it crumbled away still attached to the old line.
do I need to come up with a way to anchor the new line to something, or is it fine to just hang between the wheel cylinder and the little block on top of the diff? It’s a 30” line, I’ve about a 2’ span.
Long story short, I’ve replaced the line with Ni-Cop, but the bracket that anchored the original line is gone. Total rust, it crumbled away still attached to the old line.
do I need to come up with a way to anchor the new line to something, or is it fine to just hang between the wheel cylinder and the little block on top of the diff? It’s a 30” line, I’ve about a 2’ span.