- Joined
- Mar 28, 2017
- Messages
- 180
- Reaction score
- 17
- Points
- 18
- Location
- MS
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0L EFI
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
- Total Lift
- 4"
- Tire Size
- 31 X 10.5 X 15
- My credo
- Duty, Honor, Country
When I did my 87 BII 4X4 5.0 AOD swap I went with a set of 96 Xplorer cast iron exhaust manifolds. I now have a set of BII/Ranger V8 swap headers I can use but don't really want to go through the hassle of pulling the motor again.
Have any of you installed headers after you completed your swap without pulling the motor to install them?
Thanks!
Have any of you installed headers after you completed your swap without pulling the motor to install them?
Thanks!