- Joined
- Aug 23, 2007
- Messages
- 4,690
- Reaction score
- 20
- Points
- 38
- Vehicle Year
- 1984, 1999
- Make / Model
- Ford
- Engine Size
- 2.8L, 3.0L
- Transmission
- Manual
I am just going to swap my fron yokes in the manual I put in and the electric i pulled out if its not to labor intensive. so What holds the front cup yoke on the 98+ ranger T cases in? snap ring on the inside?
I know the manual one I have has a front yoke with a nut holding it on, will i have to swap shafts? threaded to (what i am assuming) non threaded cup shaft?
And lastly what is the size and thread on the manual shifter adjustment bolt, the little one behind the large pivotal one.
I know the manual one I have has a front yoke with a nut holding it on, will i have to swap shafts? threaded to (what i am assuming) non threaded cup shaft?
And lastly what is the size and thread on the manual shifter adjustment bolt, the little one behind the large pivotal one.