94-97 5 speed

[RobbieD]

You're getting there.

If you end up with an extra rubber shifter boot, that's good, and you want to sell it, please keep me in mind.

 

[toolman60]

dad burn,

I had another in my hand today and left it there.

 

[Josh B]

The shifter don't come with the transmission? How much was the 5 speed and drive shaft

 

[don4331]

A SuperCab? I would have been looking for a single piece driveshaft from a newer Ranger to eliminate the center bearing, a u-joint and a bunch of vibration. (All SuperCabs have same wheelbase, transmissions end at same point, so length is determined by 2 or 4wd. You might need correct yokes at axle*, but otherwise it should just fit)

*Given it is is SuperCab, axle should have the larger plate anyways, but this is Ford...

 

[toolman60]

The transmission,shifter,driveshaft was 240$ The wiring harness floor plate for 5 speed, 2 speedometer gear assembly 2 shifter accessory mounts 1 with cup holder 1 no cup holder ( just the square mounting ring for shifter boot) 2 shifter boots,clutch/brake pedal assembly was 40$

 

[toolman60]

Ok members,

Anyone have a line on pressure plate bolts that will fit in the LUK flywheel?
I hate to go back to pick and pull to drop a transmission for a set of bolts for the pressure plate. I may make a trip anyway just to go ahead and pull another 5 speed and get all the needed bolts and a 5 speed to have spare parts if needed.

 

[Shran]

Ok members,

Anyone have a line on pressure plate bolts that will fit in the LUK flywheel?
I hate to go back to pick and pull to drop a transmission for a set of bolts for the pressure plate. I may make a trip anyway just to go ahead and pull another 5 speed and get all the needed bolts and a 5 speed to have spare parts if needed.

I think in a pinch there would be no problem just using regular bolts from the hardware store. I don't recall if they are SAE or metric though but they are about 1/2" long. If you can get grade 5 or 8 or 8.8 metric, with a flange head, that is what I'd use... or a regular bolt, washer and blue lock-tite. I probably would not use a lock washer on that application.

 

[toolman60]

My ACE Hardware has a great selection of Metric an SAE bolts and they also have grade 8 and of course they will be getting a drop of blue on them. I am just trying to get as much together before I start tear down as I can.