• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

'88 Nissan "850" D21 HardBody


Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
Replaced the single piston calipers with the V6 dual piston calipers and bigger rotors.
59918

59919

I did change the hoses too, and was a little concerned about how the sat, but no worries, after a test drive they did not rub the tires. I also repacked the bearings with new grease, the stuff that was in there looked like old motor oil. I also cleaned and painted the brake dust covers. When I took them off to trim for the bigger brackets, I stripped out one of the aluminum screws used to hold it on, one each side lol, and had to drill off the screw head, but left the shaft as a little holding stud. I dabbed some hi-temp gasket maker on the stud to keep it from vibrating in the future, we'll see how that works. After bleeding the brakes, I took it for a test drive, and it stops,
.
 


Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
Didn't do the tie rod ends, waiting to get more parts. BUT, I did take out the explorer console that was in there and put in an actual Nissan console. It came out of a much newer truck and the rear bracket is supposed to attach to a small airbag computer that I do not have. So i had to fab up a bracket.
I started with a 4" piece of 2x3 aluminum angle
59920

And two 5" pieces of 1" aluminum square tube

59921


59922

Finished the home made bracket
And... Wha La
59923
 

Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
My Mirrors have always been a weak spot of the truck. The PS mirror had a huge round, convex, bubble type of thing bolted to it, and the DS mirror always tilted down when I shut the door.
59950

Not sure what year it was, I forgot to look. But what I did notice, was that the Xterra mirrors looked like they would fit my D21.
So I snatched one off the Xterra, and dry fit it to the HB in the yard, and WHA-LA, a match.
59951

I dry fit them on my HB, and instantly noticed I had some cutting to do.
59952


59953

After everything had been mocked up and fit well, It was time for some protection on the fresh cuts, so a quick tape up, some sanding and primer before a shot of Gloss Black, Thankfully the mirrors covered up most of my work. lol
Just for comparisons sake. The Xterra mirrors are definitely beefier

59954


59955
 

Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
Well, With some extra time, I thought I would clean the engine up some more. I decided to remove a connection for hoses that I had previously just plugged, and make a plate from galvanized sheet metal. All thing were going well until I cross threaded a bolt and it snapped when I tried to back it out. FML
59957

My plan was to seal the hole with a bead of gasket maker around it. So that's what I did. But with the broken bolt in the hole, I couldn't get a good tight seal. I didn't want any air seepages, so I sealed the edges of the plate too. I decided to paint my bracket white while I had it off. IDK why, but I like it.
59958

Originally, each bolt on the right had a ground attached, so I just move the top on to the bottom. I hope that wont cause problems down the road.
 

Jim Oaks

Just some guy with a website
Administrator
Founder / Site Owner
Supporting Vendor
Article Contributor
TRS Banner 2010-2011
TRS Banner 2012-2015
TRS 20th Anniversary
VAGABOND
TRS Event Participant
GMRS Radio License
Joined
Aug 2, 2000
Messages
13,410
Reaction score
8,530
Points
113
Location
Nocona, Texas
Vehicle Year
1996 / 2021
Make / Model
Ford Ranger
Engine Type
4.0 V6
Engine Size
4.0 / 2.3 Ecoboost
Transmission
Automatic
2WD / 4WD
4WD
Total Lift
6-inches
Tire Size
33x12.50x15
My very first vehicle was a Datsun pickup my dad gave me back in the 80's. Fun little truck.
 

Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
My very first vehicle was a Datsun pickup my dad gave me back in the 80's. Fun little truck.
This is my 2nd Nissan. I had a 720 (datsun pickup) for a few years in the 90's. Back when I was in to minitruckin'
 

Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
59973

This is what years of vice grips for window cranks looks like.
So I replaced them
59974

Now I can use these
59975
 

Jim Oaks

Just some guy with a website
Administrator
Founder / Site Owner
Supporting Vendor
Article Contributor
TRS Banner 2010-2011
TRS Banner 2012-2015
TRS 20th Anniversary
VAGABOND
TRS Event Participant
GMRS Radio License
Joined
Aug 2, 2000
Messages
13,410
Reaction score
8,530
Points
113
Location
Nocona, Texas
Vehicle Year
1996 / 2021
Make / Model
Ford Ranger
Engine Type
4.0 V6
Engine Size
4.0 / 2.3 Ecoboost
Transmission
Automatic
2WD / 4WD
4WD
Total Lift
6-inches
Tire Size
33x12.50x15
My Datsun looked like this, red with the ST stripes, but it was 2WD.

I actually looked for a Datsun 4x4 back in the early 90's, but couldn't find one. I eventually ended up with a Ranger.

datsun_pickup_st_720.jpg
 
Last edited:

Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
My Datsun looked like this, red with the ST stripes, but it was 2WD.

I actually looked for a Datsun 4x4 back in the early 90's, but couldn't find one. I eventually ended up with a Ranger.
I cant see a pic, if you posted one.
Definitely a 720 if it was an "ST" Should have the smooth bed without the hooks too.
 

Jim Oaks

Just some guy with a website
Administrator
Founder / Site Owner
Supporting Vendor
Article Contributor
TRS Banner 2010-2011
TRS Banner 2012-2015
TRS 20th Anniversary
VAGABOND
TRS Event Participant
GMRS Radio License
Joined
Aug 2, 2000
Messages
13,410
Reaction score
8,530
Points
113
Location
Nocona, Texas
Vehicle Year
1996 / 2021
Make / Model
Ford Ranger
Engine Type
4.0 V6
Engine Size
4.0 / 2.3 Ecoboost
Transmission
Automatic
2WD / 4WD
4WD
Total Lift
6-inches
Tire Size
33x12.50x15
I cant see a pic, if you posted one.
Definitely a 720 if it was an "ST" Should have the smooth bed without the hooks too.
Fixed it.
 

Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
@dvdswan may know more than I do, but I thought the ST trucks had the smooth bed sides with "no hooks"
 

Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
My Datsun looked like this, red with the ST stripes, but it was 2WD.

I actually looked for a Datsun 4x4 back in the early 90's, but couldn't find one. I eventually ended up with a Ranger.

View attachment 60517
mine looked like this, but had wide chrome rims and was lowered. Blue interior.
60519
 

89Twincharge

Active Member
Joined
Aug 25, 2016
Messages
265
Reaction score
182
Points
43
Vehicle Year
89
Make / Model
Ford
Transmission
Manual
Nice build keep it it in the family
 

dvdswan

Well-Known Member
U.S. Military - Veteran
Joined
Feb 11, 2021
Messages
2,832
Reaction score
2,899
Points
113
Location
Seattle, WA
Vehicle Year
1991
Make / Model
Ranger XLT 2WD
Engine Type
3.0 V6
Transmission
Automatic
2WD / 4WD
2WD
My credo
Keep your mind like an umbrella, it only works if its open... Continually learning.
1980-1984 had the hooks on the side. 85-86 had smooth sides. 83 I think was the 1st year to have "Nissan" in big letters on the tailgate.

ST was just a package just like STX is to Ranger.

60549


60550


This was mine. Ignore the 80s hair style.

img003-1.JPG
 
Last edited:

Ranger850

Doesn't get Sarcasm . . .
TRS 20th Anniversary
Joined
Jan 24, 2018
Messages
8,426
Reaction score
4,664
Points
113
Location
Tallahassee Florida
Vehicle Year
2001
Make / Model
Ford
Engine Size
Born with a 3.0, looking for a donor V8
Transmission
Manual
2WD / 4WD
2WD
Total Lift
Stock 2"
Tire Size
Stock
My credo
Doing things wrong, until I get it right.
60808

Went from this
60809

To this
 

Sponsored Ad


Sponsored Ad

Staff online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Kirby N.
March Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top