MarkusMcBride
Member
- Joined
- Aug 18, 2015
- Messages
- 56
- Reaction score
- 9
- Points
- 8
- Location
- Western Canada
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Type
- 2.9 V6
- Engine Size
- 2.9
- Transmission
- Manual
- 2WD / 4WD
- 4WD
Hi, so I just installed my aftermarket Kenwood deck in my 87 Ranger. The original radio was AM only so I assume the truck had the most basic package. When I got the new deck in, I discovered that the rear speakers dont exist and I was unable to find any wiring to them. I am disappointed but I have speaker wire.
How best do I wire these back speakers in? The harness for the speakers only has 3 wires which I found strange. Usually its 2 wires per speaker but theres only 3. Do I need to pull a harness out of a scrap yard and run the wiring back?
Please shoot me some advice if you have seen this before. I was really surprised to find no wiring to the back. The speaker covers/holes are there.
How best do I wire these back speakers in? The harness for the speakers only has 3 wires which I found strange. Usually its 2 wires per speaker but theres only 3. Do I need to pull a harness out of a scrap yard and run the wiring back?
Please shoot me some advice if you have seen this before. I was really surprised to find no wiring to the back. The speaker covers/holes are there.