MadMax_636
Active Member
- Joined
- Nov 7, 2019
- Messages
- 520
- Reaction score
- 47
- Points
- 28
- Age
- 28
- Location
- Georgia
- Vehicle Year
- 1984
- Make / Model
- Ford Ranger
- Engine Type
- 2.8 V6
- Engine Size
- 2.8L
- Transmission
- Manual
- 2WD / 4WD
- 2WD
- Total Lift
- However much it goes up when I get my fat ass out.
- Total Drop
- How much it goes down when my fat ass gets in.
- Tire Size
- Dry rot and old
As the title states. Im stuck in the part picking phase. I dont know what transmission mounts, driveshaft, and clutch I need to get. Since the transmission is for a 4.2L v6 but going onto a 302. Im assuming the bell housing is smaller so id need a smaller flywheel. Also what starter would/should I use. Could I use the starter from the 2.8?