• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

4 wheeling/mud bogging advice


Ty's toy

New Member
Joined
Mar 12, 2013
Messages
11
Reaction score
0
Points
0
Location
Pa
Vehicle Year
1997
Make / Model
Ford
Engine Size
4.0
Transmission
Manual
Hey guys im new to this forum and imlooking for some advice.

I have a 97 ranger that I take muddin everyonce in a while...but im looking to get into it some more

I would just like some advice to make it better and less likely to break offroad

Like breathers and such

What should I do?

Its lifted 4 inches as of now and 31s are coming soon

Any tire suggestions?

Thanks, any help would be appritiated
 


85_Ranger4x4

Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
Joined
Aug 7, 2007
Messages
32,130
Reaction score
17,341
Points
113
Location
SW Iowa
Vehicle Year
1985
Make / Model
Ford
Engine Type
V8
Engine Size
5.0
Transmission
Manual
Extend the axle breathers. Check the front axle bearings and gear oil after each time if they get below the mud line.

Ask around your area about tires, different tires work better in different soil types and soil types can vary wildly even in a given area.

My favorite mud tire to date for both highway and mud is the BF Goodrich MT in the Jeep Rubicon tread pattern. You can only get them in a few tire sizes though. Fairly quiet on pavement, decent on snow pack and they seem really good in mud. The others I have ran is Dunlop Mud Rovers (loud on pavement, scary on snow, very good in mud) and Firestone Destination MT's (not bad on pavement, mediocre on snowpack, pretty good in mud)

You can get them milder and wilder but for what I do I really like my BFG's.
 

Ty's toy

New Member
Joined
Mar 12, 2013
Messages
11
Reaction score
0
Points
0
Location
Pa
Vehicle Year
1997
Make / Model
Ford
Engine Size
4.0
Transmission
Manual
ive been looking around and I really like the look of the ,falkon rocky mountains, and the general grabbers, have you heard anything about them?

Thanks again for the help
 

94 lngbd

New Member
TRS Banner 2010-2011
Joined
Nov 24, 2007
Messages
862
Reaction score
7
Points
0
Age
59
Location
Lakewood,Wa
Vehicle Year
1994
Make / Model
ford
Engine Size
2.3l
Transmission
Manual
both the General & Falken tires you mentioned are AT tires & wouldnt be that great in MUD
 

BLOODBANE

Active Member
V8 Engine Swap
TRS Banner 2010-2011
Joined
Aug 7, 2007
Messages
1,119
Reaction score
19
Points
38
Location
Canon City, CO
Vehicle Year
19841994
Make / Model
FORDFORD
Engine Size
347, 4.oh
Transmission
Automatic
This...

For mudding, but don't expect a very long road life on them....
 

85_Ranger4x4

Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
Joined
Aug 7, 2007
Messages
32,130
Reaction score
17,341
Points
113
Location
SW Iowa
Vehicle Year
1985
Make / Model
Ford
Engine Type
V8
Engine Size
5.0
Transmission
Manual
both the General & Falken tires you mentioned are AT tires & wouldnt be that great in MUD
I can't believe the places I went with wussy AS car tires, it is even harder to believe I even tried it. :shok:
 

Ty's toy

New Member
Joined
Mar 12, 2013
Messages
11
Reaction score
0
Points
0
Location
Pa
Vehicle Year
1997
Make / Model
Ford
Engine Size
4.0
Transmission
Manual
Well im looking at the general grabber red label...they are supposed to be for mud?
 

hdmm

New Member
Joined
Feb 2, 2009
Messages
80
Reaction score
0
Points
0
Location
Flagler County, FL.
Vehicle Year
1997
Make / Model
Ford
Engine Size
3.0
Transmission
Automatic

FritzTKatt

New Member
U.S. Military - Veteran
Joined
Mar 9, 2012
Messages
707
Reaction score
4
Points
0
Location
Ohio
Vehicle Year
04
Make / Model
Ford
Engine Size
3.0
Transmission
Automatic
Good year wrangler duratrac.

Extend your breathers, check your seals, make sure the wiring harnesses are sealed, silicone grease all connections. Put manual hubs on. That'll be your first upgrades.

Take it easy and learn how to drive off road. Don't go blowing through holes and doing 30 over washboards. Always go out with another truck and have recovery gear. If you're stuck, you're stuck. Don't dig it to the frame... but we've all done it...
 

DRanger024

Well-Known Member
Supporting Member
Solid Axle Swap
GMRS Radio License
Joined
Aug 16, 2007
Messages
851
Reaction score
476
Points
63
Location
Dale, WI
Vehicle Year
1994
Make / Model
Ranger
Engine Type
4.0 V6
Transmission
Manual
2WD / 4WD
Solid Axle Swap 4x4
Total Lift
6-7” front maybe 3” rear
Total Drop
0
Tire Size
33x12.50-15
Duratracs are not a dedicated mud tire either. They're horrible on our little trucks in winter as well when you start getting into the 33" and up range.
 

PanamaExpat

Active Member
Joined
May 28, 2011
Messages
1,076
Reaction score
13
Points
38
Location
Panama City, Rep. of Panama
Vehicle Year
1994
Make / Model
Mazda
Engine Size
4 liter
Transmission
Manual
Don't forget the breather on the transfer case. It holds the least amount of lube in the drive line and ATF doesn't like water. Remember when the t-case takes a dump on you you go nowhere.
 

509lifted

New Member
Firefighter
Joined
Nov 12, 2011
Messages
997
Reaction score
10
Points
0
Age
30
Location
chelan washington
Vehicle Year
1984,1992
Make / Model
ford
Engine Size
2.8l, 4.0 v6
Transmission
Manual
actually dranger they are great on our trucks, go look it up nothin but great reviews on here for them and a guy that did a test in mud, sand, pavement wet and dry, snow, ice, dirt, and minor rock use and had nothing but great to say about them.
 

FritzTKatt

New Member
U.S. Military - Veteran
Joined
Mar 9, 2012
Messages
707
Reaction score
4
Points
0
Location
Ohio
Vehicle Year
04
Make / Model
Ford
Engine Size
3.0
Transmission
Automatic
I'll swear to mine up and down all day. Maybe bigger sizes than 31s have problems, but I've driven in all conditions and never had problems. Everyone else I see with them loves them too.

One really important thing besides the breathers is recovery points. If you can't get pulled out, or pull someone else out safely, then you're screwed and can break things or people get hurt. To start off with, a class 3 hitch or stronger in the rear, and 2 hooks up front will take care of you. When you install the hitch don't be lazy and just use the 2 existing holes. Drill 2 more and fill up all applicable slots in the brackets. Regular hooks are ok, but spring loaded keepers are better.

A front mount hitch is best combined with hooks. Then a winch can eventually be mounted directly. If you have the time/$ go directly to building a custom bumper. In the fabrication section there are multiple threads including mine.

Always be safe and don't go crazy. Especially combining alcohol or drugs off road, go out in the boondocks, party, sleep it off, then drive out. Always respect the land you travel and leave nothing but ruts hehe.
 

Ty's toy

New Member
Joined
Mar 12, 2013
Messages
11
Reaction score
0
Points
0
Location
Pa
Vehicle Year
1997
Make / Model
Ford
Engine Size
4.0
Transmission
Manual
Thanks for all the advice guys..i really appreciate it
 

Sponsored Ad


Sponsored Ad

Staff online

Today's birthdays

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Kirby N.
March Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top