Eddo Rogue
Well-Known Member
- Joined
- May 18, 2020
- Messages
- 3,982
- Reaction score
- 2,502
- Points
- 113
- Location
- Burbank,CA
- Vehicle Year
- 1993
- Make / Model
- Ranger 4x4
- Engine Type
- 4.0 V6
- Engine Size
- OHV
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Total Lift
- skyjacker front leveling kit
- Tire Size
- 31-10.50R15
- My credo
- Crossed threads are tight threads.
I'm looking into 3 axis welding clamps, and also a drill press clamp.
Most of the stuff I make at involves 3 axis 90's. I think these would save me a lot of time and material building jigs and messing around with single clamps, and more easily staying within tolerance. I realize I would need 4 of them. and the good ones start around $200 bucks.
Same with the drill press cramp. I seem to always catch the ridges using regular clamps, and or drill the plate...or recklessly and lazily freehand it. A drill press clamp may prevent that...
I have found a few name brands for pretty cheap....
Any advice?
Most of the stuff I make at involves 3 axis 90's. I think these would save me a lot of time and material building jigs and messing around with single clamps, and more easily staying within tolerance. I realize I would need 4 of them. and the good ones start around $200 bucks.
Same with the drill press cramp. I seem to always catch the ridges using regular clamps, and or drill the plate...or recklessly and lazily freehand it. A drill press clamp may prevent that...
I have found a few name brands for pretty cheap....
Any advice?