Gene/Kenneth
New Member
- Joined
- Jan 27, 2022
- Messages
- 4
- Reaction score
- 0
- Points
- 1
- Location
- Detroit lakes mn
- Vehicle Year
- 2001
- Make / Model
- Ranger
- Transmission
- Automatic
I’m new to forum so hope this is right spot. Have a 2001 4x4 ranger. 4.0 auto. 4x4 not working at all. Just got pickup, no 4x4 lights on dash. Other lights work. Check fuses good. Remove connector from four wheel module and can hot wire yellow and orange wire and motor runs below. Scan tool bring up (comm failure or no controller available. )The data link wire is good to module. I want to see the light on dash light up for 4 low and high so I grounded wires gray and light blue at module and no lights, should this have worked. There is no clicking coming from module, it has been replace by one from salvage before me. wire from control selector knob are good to module. Again would like to see lights on dashboard light up for 4 wheel drive. Thanks