- Joined
- Nov 4, 2009
- Messages
- 1,713
- Reaction score
- 14
- Points
- 0
- Location
- marquette, MI
- Vehicle Year
- 2000
- Make / Model
- Ferd
- Engine Size
- 4.6
- Transmission
- Automatic
Need to come up with a rear driveshaft for the explore since i have brought it into contact with rocks a few too many times. rear shaft was extended after the SAS so getting a factory shaft is sorta outta the question current unit is 49 +/- 1/4''
Can anyone give me a rough measurement of the rear section of a ranger 2 piece driveshaft? if it is anywhere close to being the right length then i will run the the junkyard and verify it will or wont work. issue is junkyard hours and work hours conflict so when i need to go there i have to take time off. ide hate to take the time off to be nowhere in the ballpark. and then be further away from ordering a custom one.
Can anyone give me a rough measurement of the rear section of a ranger 2 piece driveshaft? if it is anywhere close to being the right length then i will run the the junkyard and verify it will or wont work. issue is junkyard hours and work hours conflict so when i need to go there i have to take time off. ide hate to take the time off to be nowhere in the ballpark. and then be further away from ordering a custom one.