smoker_xr
New Member
- Joined
- May 24, 2008
- Messages
- 9
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1991
- Make / Model
- Ford
- Engine Size
- 2.3
- Transmission
- Manual
Any tips for removing and replacing the oil pump for the 2.3 in my 91 XLT Ranger?
I have my Ranger up on ramps from where I pressure washed most of the grime off of the bottom.
Is this one of the ones with a four piece oil pan gasket, or just the one piece?
My Clymer manual says I have to take out the radiator and disconnect lots of different connections. If I'm only raising the engine off the mounts an inch or so, do I really have to have it nearly ready to pull the engine (or so it seems)?
Thanks
I have my Ranger up on ramps from where I pressure washed most of the grime off of the bottom.
Is this one of the ones with a four piece oil pan gasket, or just the one piece?
My Clymer manual says I have to take out the radiator and disconnect lots of different connections. If I'm only raising the engine off the mounts an inch or so, do I really have to have it nearly ready to pull the engine (or so it seems)?
Thanks