• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

wiring


  1. HID retrofit wiring? HELP

    I just finished retrofitting a set of h1 mini projectors into the stock housings of my 01 mazda. I cant figure out the wiring. The truck harness has a HB5 connector but the kit is H1 bulbs with a shutter in the projector. I am a noob at wiring and I cant figure out how I should wire everything...
  2. Protowrxs

    Rescued Ranger / Yet Another 4.0 Swap

    Rescued Ranger / Yet Another 4.0 Swap (YA4.0S) Little back story: 1989 2.9L 5sp XLT 4x4 - given up for dead, PO had pulled intake, said it was getting gas in the oil and filling up the pan, left it sitting open topped and no rear window. I picked it up for $400 which may have been a bit much...
  3. 93-97 ranger fog lights

    hey guys, new to the ranger station and hoping you guys can help. i have recently bought the lower fog light valance for my 94 ranger. I have ran into a few problems in the process. 1) my truck didnt come factory with the fog lights so i have no rocker switch. 2) I can't find the brackets that...
  4. Wiring diagram for 1990 2.9

    I am starting a 4.0 engine swap into my 1990 B2. As suggested elsewhere at TRS I obtained the Chilton's manuals for both vehicles, but there it shows no wiring diagram for the 1990 2.9. Chilton's only shows diagrams for the 2.3 and 4.0 for 1990. Do I assume the 2.9 engine wiring and the 4.0...
  5. 88stepside

    Wires for stock gauges

    Looking for info on what wires run what gauges. Want to use my dash gauges. Not much left of the wire harness other than a few stubbs through the firewall. Thinking I'll have to pick up sending units for the original 2.0L?
  6. Ignition Switch Harness

    Hey peeps, I just took the cover of the steering column, and i don't see the ignition harness. I'm tryin to install a Remote Starter. I unpluged every connector there and the truck still starts, and i don't see anymore wires, what am i missing? Can someone point me in the right direction in...
  7. speaker radio diagram?

    hello i have a 1989 ranger that has no radio or radio wires i want to try and put one in does anyone have a wiring diagram for the peakers and radio? the plug is till there but there are no wires to the speaker?
  8. Not Just Another Speed Sensor Problem...

    Alright guys, I have absolutely no idea about what the hell is going on with the truck lately. About 2 1/2 months ago, I started the truck up and went for a drive down the street. Everything was fine until I looked down, the speedometer's dead. I went home, checked the VSS and replaced it. The...
  9. captainnova

    Help? 86 Bronco II stereo colours

    Hey everyone, so as the title says.. I have an 86 B2, and I've been trying to hook up a newer panasonic CD player in lieu of the stock cassette am/fm. First I'd like to know which wire in the truck goes to the Yellow constant 12v+ on the stereo. And then which wire goes to the Red switched...
  10. New stereo dimmer wiring

    I got a JVC Arsenal KD a615 from my brother for christmas (As well as a set of speakers, but the main ones don't quite fit into the door and I have no tweeter spots), spent many hours trying to translate the wiring from the new wiring of the stereo to the wires in my truck. I got the speaker...
  11. help with wiring msd ignition, voltage regulator and alterantor??

    im swapping an 84 5.0 into a 89 xlt ranger if posted this before but i havent understood the answers fully. i need everything how to wire all the electric engine components (not sensors) like the ignition starter voltage regulator and the alternator an indepth picture or explanaion would be...
  12. fuel questions

    im swapping a 84 5.0 carb motor into an 89 ranger and im trying to retain the stock fuel sytem. I need to know what the wires are coming out of the top of the sending unit and how to wire them to a relay? Can i use the stock lines and then run 1/4" lines to the regulator at the quick...
  13. a couple of questions?

    im using a explorer hd radiator what hoses d use for an 84 5.0 swap into an 89 ranger? any ideas/pics of a hydralic clutch assembly for a t5? what type of throtle cable can be used fr the carb swap? does anyone know how to wire the alternator and voltage rgulator from the 84 5.0 intote pickup...
  14. Help!! 2.9 to 4.0 wiring change

    HELP !! I'm swaping from my 89 Bronco II 2.9 to a 93 Explorer 4.0. Can anyone help me with the wiring change ?? You can e-mail me at dapatt2002@yahoo.com
  15. msd wiring problems!!

    i need help with wiring my 89 ranger which im currently in the middle off swapping an 84 carb 5.0 im using an msd 6200 ignition module. i need to know where i hook the the small red wire up to the ranger so i can start it up thanks:icon_confused:
  16. 89 5.0 swap durspark II wiring from key??

    i have an 89 ranger xlt that im currently swapping a 84 5.0 carb mustang motor into it has a duraspark II ignition sytem and i need help wiring it all up so any help would be great but i need from the key to the ignition module, starter solienoid ect.. the whole deal thanks...
  17. Off Road Lighting Question

    Hi, i have a 2009 ranger sport 4.0L and i recently installed a set of PIAA 510 driving lamps, i have every thing hooked up exept for the "switch power" wire, i had it run directly to the battery and they work, but i would prefer that it be wired so it gets power when i turn the ignition on, any...
  18. 84 Ranger - Putting in Stereo System+

    I got an old 84 Ranger off my cousin it had been sitting up a while in his back yard (I think about two years) it still had the factory radio and no one had done any work on it in a while. It looks surprisingly similar to the January 2010 Street Truck of the Month :icon_thumby: (Even the same...


Top