-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
twin i beam
-
Twin I Beam Fabrication Question
I have a question regard material selection. My build is a 94 ranger 2wd (Mild prerunner). Is getting a gm LS motor. 4 link in rear likely. Front I'm building my own TIB's. I'm not concerned about building the beams as I have a lot of fabrication buddies that know what there doing. However, I...- Mb4343
- Thread
- Replies: 10
- Forum: 2WD Suspensions & Frames
-
2.3 tib removal to remove the oil pan?
I'm thinking about getting a 97 ranger for my turbo project and I'll need to put my forged pistons in.. my main question would be while I have the tib out would it be possible or worth it to remove whatever left to drop the pan and get access to the crank?- Rbj999
- Thread
- Replies: 1
- Forum: 4-Cylinder Engines (1983-2011)