transmission problems

Hey guys, I just bought my first ranger, a 02 Fx4 4.0 with a manual. I love the truck and it's got only 92k on it. When I bought it the clutch pedal felt a little soft and about a day later the master cylinder went out on me. I believe the truck sat for a little bit of its life. After replacing...

Hey there folks, I have been reading every post about this issue for hours and none of them addressed my issue or they did not have a complete thread. I have a 2000 Ranger 4x4, 4.0 V6 (V.I.N. 1FTYR11X6YPA36711). According to all that I have found, it should be the 5R55E. When I got it (used)...

I need some help figuring out what the noise is coming from my transmission is? i got the truck last year, before i got it ,it had sat in a field for 4 years and did not run . I got it to run and drive , i have replaced the clutch, slave cylinder, and master cylinder, and changed the trans...

I own a 1985 ford ranger 4x4 with a FM-145 5-speed and I have a problem of not being able to get into first gear at all. I still have reverse and 2-5 gear. there is no grinding sounds. I took off the pan cover on the bottom and the oil looked fairly new and felt fairly new yet. also...

Rebuilt the SOB and everything was working fine, then one day she started popping out of 5th and wont stay in! I can hold it in while I am driving, but it wont stay. I inspected all of the gears before reassembling, but maybe I didn't notice some wear on the 5th gear counter? I did in fact amke...

hi guys I have an intermittent problem with my ranger - the speedon stops working and the transmission wont shift to any forward gears leaving the vehicle in 4th. reverse engages fine... but no 1/2/3 or O/D Both occur simultaneously and Ford say its not the VSS (they dont know whats causing...

My son's B2 was stuck in gear and then slipping in and out and then not going into any gear at all. We have taken the shifter out and found a plastic "thimble looking" part that the round ball end of the shifter goes into. The piece is broken all around the top and sides. Was told by a mechanic...

So I went off roading and launched off a jump in my prerunner and cased the landing, I bottomed out my rear susspension enough to buck my rear wheels off the ground and nose wheely for a few feet. After that I went to step on the throttle to keep going but my truck would just rev as if it was in...