torsion

My 2004 2wd Edge no longer sits up level (or close to level) like a 4x4 as it should. I started to notice this after the engine was replaced a few years ago. It has gradually sagged lower. Looking at it from the side, it looks higher in the back and lower in the front. It used to sit level. I...

Ok, here's the basics: I'm mechanically minded. I do all my own maintenance and modifications to the motorcycles I own, my son races motocross and I'm the acting mechanic for his bikes as well. I've done a large number of electrical modifications to cars and trucks over the years and I'm...

This past weekend I finally decided to level my truck by cranking my torsion bars. Initially, my truck sat at 34.5" from ground level to the bottom of fender wells. I only wanted to crank them 1.75" so as not to cause too much wear on my front end components. I was able to crank them to achieve...

i have a 99 ranger and would like to raise the front just a little with low costs...should i crank up the torsion bars a little? are there any other better ways. give me your input