• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

test

  1. Jonny Jekyll

    2002 XLT 4.0 SOHC Throttle Position Sensor Test/Mod

    I want to retest my TPS to make sure it's at 96v, I've done it before but I can't remember which terminals go where. And if you need a ground or which setting to use for the volt meter. I can't find thread which has the pictures of how to use the volt meter with it. Is there anyone out there who...
  2. 1985 2.3L Compression check

    The sticky thread at the beginning of this forum does not provide the nominal compression for this engine. Just tested mine with the following results Dry Test Cyl = PSI 1=165 2=160 3=158 4=175 Wet Test Cyl = PSI 1=260 2=270 3=265 4=250 I need some specs to tell me if these are in range...
  3. Compression Test Results

    1996, 2.3 liter ford ranger with 207k miles on her. I recently replaced the head gasket and repaired a handful of vacuum leaks. Symptoms: poor idle rough start while cold impossible to start while warm smell of gas after second attempt, however it could be I'm flooding it trying so much...

Sponsored Ad


Sponsored Ad

Top