starting

Hi everyone, i'm from germany and in january i bought a 1986 ranger (which is an import car), unfortunately it broke down couple weeks after i bought it, the reason was a broken crankshaft. So i took it to a U.S Car workshop in germany (which are btw extremly rare) and the guy told me he will...

:annoyed: 2003 xlt w/V6 4sp manal No error codes to read, but here's what happens: If it's been raining all night, I start it up, if I press the gas, it will stall until the engine has warmed a little. If I try & take off, it'll stall every time until warmed. Same seems to happen when it's...

I have a 1987 2.9L Ranger that has the stock ehxaust. I was thing of running headers to a flowmaster 40, the part I need help with is what type of headers should I get/ also I heard I should use a 2 1/2 inch pipe or a 2 1/4 inch pipe which would be better and where would I buy this? I was...

have a 2006 Ranger STX with the 3.0 Vulcan 6 banger in it and have a issue that is boggling me to death... Fuel pump assembly changed, Fuel pump sock changed, Fuel filter changed, All hoses and related connections checked no leaks, No fuel smell nor leaks found, Fuel pump relay changed...

I posted a while ago about issues I was having with my '88 Ranger, in which the previous owner swapped a 4.0 from a 92' Explorer into. Apparently all the issues stemmed from him using the original 2.9 harness for the computer and some of the sensors, and splicing everything into the 4.0. I don't...

Hello all, I am at the end of my rope on this and looking for help. I have a 1994 ranger 2.3 2wd that has a no start, no click. I have replaced the solenoid, ignition switch, and the clutch position switch. The only thing I know is left is the ignition lock cylinder. Is it possible this could be...

My mom's ranger doesn't want to start with key but if you jump the terminals on the solonoid it starts is this an ignition wire on starter faulty or solonoid?

Good day everyone. I have a very strange problem. I have a 03 Ranger, 188K. I just completed a transmission filter change, and also purchased a new battery. I drove it up and down block to make sure all was Ok, went out one week later, engine won't turn at all. A starter was replaced last...

I have a 1989 Ford Bronco II 4X4 XLT it has the 2.9l EFI with the redesign heads. It has 150,000 miles 4-speed OD manual trans, manual hubs, manual transfer case. I have noticed that it is reluctant to start, but its more complex than that. I turn the key, wait for the fuel pump to stop...

I have a 99 Ranger 4.0 V6 4x4 that is having trouble starting on cold mornings. I have done a little research but I am lost at how many problems can have similar symptoms. So far, all I have tried to to replace the fuel pump relay. Now I don't hear the pump coming on when I turn the key on...

Drove my truck to the store a few weeks ago and when i got back in it to leave, it wouldnt even try to crank....Sometimes when i key on, the dash lights come on, other times they dont. When they do come on, as soon as i turn the key to the start position they truck goes dead (electrically). In...

I have a 1995 ford ranger 2.3L all stock. In the beggining it starts fine, but after driving around town and turning the engine off, I cant run the truck right back on until I wait like for 3 or 5 minutes and then it will run. I dont know whats the problem, it cranks and the radio and lights...

Hi guys. I installed a SOHC motor from a 2001 Ranger into my '96 to replace a 2.3L. The harness and ECU are from a '97 explorer SOHC. I am not getting any spark and I don't smell any unburned fuel. I checked the cam position sensor. It does provide an AC signal when the engine is cranked. It...

Need help with getting my 88 Ranger started. I took off for work this morning, made it into town, through a stop light, over the railroad tracks and it died. I coasted it into a parking lot, and tried to start it. It sounds like it wants to start - turns over real good - just won't actually...