starting issues

Hi all! I’ve got a 99 Ranger with the 3.0 automatic trans 4x4. I’m putting a new trans in and I was going to put a new neutral safety switch in when I did. The old switch is a 12 pin connector but all of the switches available are all 11 pin. Even the exact same part number as the one I pulled...

Hi everyone, i'm from germany and in january i bought a 1986 ranger (which is an import car), unfortunately it broke down couple weeks after i bought it, the reason was a broken crankshaft. So i took it to a U.S Car workshop in germany (which are btw extremly rare) and the guy told me he will...

1997 Ranger 2.3L on initial start Truck die almost immediately. I cycle the key multiple times and engine starts but run rough. Once drive for about 5 mins engine purrs like a kitten and starts on command. I recently had to replace the timing belt because of the old one dry rotting and breaking...

I was hoping someone could help me diagnose an issue with my truck. I've tried everything I could find, and still don't know what's going on. 1991 Ranger 4x4 2.9l manual tranny. When starting my truck (warm, cold, just turned off, doesn't matter), it takes a couple of key turns to start...

so i have had no avail to this truck its been one thing after another first the whole thing dies then after new eec it started running fine till the other day when i went to fill up and i go to start it and nothing. i get off work and go back to it and it starts fine but only when the motor is...

I am converting a 1977 Ranger body, to a 1995 f-150 4X4 frame. Does any one here now what electrical parts i need hooked up to get it to run? The parts i have are the frame, Has a 351/w efi engine. automatic transmission. and drive train. Fuel tanks, fuel pumps, I have 95 % of the wiring...

I have a 1998 ranger xlt 4.0l 5 speed 4wd truck with cranked torsion bars and 33s and it has three problems. This is going to be an essay but most of these threads are just asking questions the publisher should put out there to begin with. Check engine light reads lean banks. Shit gas mileage...

Edit: Just took the OBD-1 codes. KOEO readings were: 157 - (R,M) Mass Air Flow signal is/was low or grounded - MAF [Understandable, had the MAFS disconnected to get it started] 543 - (O) Fuel pump monitor circuit shows no power - Power / Fuel Pump Circuits KOER readings were: 173 - (R,M)...

Okay so I have had this truck for three or so years and it as o the last year it has been giving me a lot of problems. It started out about 8 months ago where I took the truck to work and I parked in the back and turned,the truck off for a few minutes to get prepared and then it wouldn't turn...