spindle

Drivers front wheel bearings quit on me, and it's looking like this spindle is done too. I have one extra (in my hand in the 2nd photo) that comparably seems to be in ok condition, but I'd really rather not replace it if I don't have to. I bought this spindle brand new almost three years ago...

I looked around the forum and watched a bunch of youtube videos, but the videos always cut and resume after the knuckle is removed. I'm trying to do ball joints on a 2002 Ranger 4x4 w/torsion suspension. Upper control arm is disconnected from the knuckle. Caliper is off. Axle nut is off and...

hi i recently bought an 87 ranger xlt 4x4, was replacing the front passenger side bearing and notice the needle thrust bearing, bearing spacer, and the axle shaft spacer are missing. mine are auto locking hubs WITHOUT an inner and outer spindle nut. the spindle nut on there is a hex nut, not a...

just bought an 87 ranger xlt in great condition, just needed new front bearings. i took off the right front hub and its missing the spindle washer and the tiny pin bearings, i was wondering if anyone knew if just that stack-up of washers is available anywhere (tried o'reilys and advance, they...

Hello everyone, I am new to the forum and have been poking around on here for a while trying to come up with something to match my issue. With no luck and tired eyes I am posting for some advice. I have an 02 B2300 2wd that I bought about 6 years ago. One year in and the 3:73 rear end went...

So I found a camburg 6.0 lift on craigslist for 800 I wanna pick up and I know it's for the edge and I have a normal 2wd with the coil springs not torsion bars. it wont work will it. I'm hoping it does like if I got the spindles and the a arms will they work on my truck. any help will be great!

Ok, so I was working on my Ranger in Auto Class. simple enough, right? Wrong. My teacher and I agreed that this is the first time the front has probably had maintenance done on it since 1986; with that being said, it's pretty ugly. We were taking out the Spindle and replacing the Bearings...

I have an 89 Ranger and manual warn hubs, the hubs are good, and i JUST replaced the driverside U joint, STILL having a loud knocking noise, i've had a friend check and it's actually the ears of the U hitting the end of the bolt holding the bottom of the knuckle (hub?), u can see it just below...