speedometer

Hello, everyone. I have a 1988 with a RPM-gauge needle broken. I want to take it out and put a new one; but I’m not sure if I just have to pull the needle and it will get off or if there is any other stuff I should do. Thanks a lot

So before I get flamed, I DID search. A lot. On several forums. I found a lot of speedometer discussions, but none that covered this issue. My speedometer and odometer stopped working. The issue is definitely in the cluster. Swapped the cluster with a spare and it works perfectly. So obviously...

I have a 1996 Ford Ranger 4.0 5 speed long-box standard cab 2 wheel drive truck with no power windows. mirrors or locks. The speedometer has recently stopped working and I have found something that does NOT make any sense. with the ECU plug connected or disconnected and the engine-cab connector...

My trusty '96 LongRanger started thowing P0171/174 codes recently and I was finding the truck a little down on power and harder to get good mileage. Now back in my younger days, my engines alway had a "lean code" because I drove Mopar slant sixes and 2.3 Vauxhalls -but that was before the days...

I plugged my OBD 2 scanner into the plug on my 1995 B4000 SE 4x4 4.0 OHV I got these codes: P0500 Vehicle Speed Sensor A Malfunction P0141 O2 sensor Heater Malfunction B1 S1 P0155 O2 sensor Heater Malfunction B2 S1 P1151 Lack of upstream heated O2 sensor _______switch; indicates lean...

My speedometer in my 95 2.3 has been sticking since I bought it last month. It will still show the right speed occasionally and if I tap the dash above the gauges the needle moves to the correct speed. Anyone have any ideas on how to fix this?

Hi all, brand new here! I have a 1998 Mazda B3000 that I think the GEM is going bad on from reading the different forum posts from here and elsewhere. The truck's speedometer and the windshield wipers don't work. This has been occurring intermittently pretty much since I got the truck a couple...

Ok, so here is the spiel. Speedometer/Odometer has not worked properly since purchase. However, on two occasions it has worked (seemingly told the correct speed, not positive didn't have gps to verify with) and then just outright quick 10-15 seconds later. I have replaced: OSS (on the...

I finally got my 93 ranger 5.0 swap up started. it sounds great. As i finish the driveshafts i figure the speed issues should be ironed out as well. Correct me if i am wrong but as i understand: -the 98 explorer 5.0 needs a speed input from the rear axle. -the 93 ranger is cable driven with a...

Hope you're having a good day! I appreciate any help that anybody might be able to offer. I'm having a *hell* of a time finding a tuner or programmer for a 2000 Ranger with a 2.5L engine. This really all started when I gave her a 4" lift (4" spindles in front, 2" shackles and 2" blocks in rear)...

Hope you're having a good day! I appreciate any help that anybody might be able to offer. I'm having a *hell* of a time finding a tuner or programmer for a 2000 Ranger with a 2.5L engine. This really all started when I gave her a 4" lift (4" spindles in front, 2" shackles and 2" blocks in...

Hi all, My dad and I are nearing the end of our EV conversion process, having taken a 1997 Ranger XL and installed 96 V of deep cycle lead-acid batteries, complete with a hinged bed and a Prestolite motor. I gave it a test drive today around the block and it runs great! Only one issue: we...

I have an 03 ranger edge with a 5.0 and T5 running a 97 explorer computer. The speedometer worked fine with the 4R70W trams out of the explorer but I swapped to a T5 out of a 2000 model mustang. It runs fine without any tune (just took the "check engine" light out because I couldn't get over...

SO I read most of the "How the speedometer works" and "Speedometer problems" threads and was able to figure out a lot. When I bought my 1994 Ranger, it had a transmission from a newer model Mazda truck in it. I recently replaced the clutch assembly and saw the speedo cable just dangling there...

i have a 95 4.0 4x4 5 speed. i dropped the transmission and did a clutch and slave cylinder and when i put it back in, the speedometer was acting up. the speedometer was accelerating alot faster then the truck. i was doing about 25 and it would say i was doing 105 and then the speed limiter...

Hello I am new to this forum but am desperate for help. I have a 99 ranger and the abs light is on speedo doesn't work o/d light flashes and it shifts hard. I have already replaced the speed sensor on the rear end twice thinking maybe the first one was bad. I've checked all the wires and...

I drive(more time repairing than driving) a 1994 Ranger extended cab, 4.0 OHV, auto tranny, auto 4x4, Dana35 front, stock 8.8/3.73 rear, 1994 uses a mechanical speedometer. I'm in the middle of a larger project where I'm servicing my power steering components and replacing rocker arms and...

Hey guys, i have a 95 xlt super cab, automatic, 3.0 with 2WABS. My odometer will randomly cut in and out. Nothing i do helps it come or go at all. I've read most of the forums on here but didn't really see anything or anyone mentioning the really thin copper cable on the bottom of the cluster...

Hi all. I've got a 1992 2wd R1. My transmission recently went out. I found a great deal on a used R1 from 1998. I know that '98 Rangers have a very different speedometer set up that does not go into the tail housing like the old days. I also noticed that the tail housing of the 98 did have a...

Been dealing with a bouncing speedometer in a '93 Ranger 4x4, 5 spd, 4.0, since I bought is used about 4 years ago. Every now and then I try something new to see if I can fix the problem, however so far no luck. I got thinking about how the cruise was also surging so figured the next option was...