rear axle

Looking for: a manual shift 1354 transfer case, from a 90-97. (With transmission plate and boot/ shift knob) Rear axle, limited slip, 3.55 gears.(code r5 on info tag) (8.8) Rear sliding glass, for a super cab (compatible with a 91) Complete Rad support, 83-88 Leveling kit, for a Dana 35. 2 ish...

I have a 92 ranger 2wd 3.0 I'm trying to install 7.5 limited slip into the previously open 7.5 . The gears are being changed to 3.73 from 3.45. My current issues. The carrier is far to one side .03 shim on driver while the other side is 1/4 inch on passenger. That's as far as the pinion will let...

My truck makes a humming/whirring noise that seems to reverberate up through the bed and cab as I accelerate and am maintaining 25-50 mph speeds. Even at highway speeds, you can still hear it. I have thought that most likely it is the rear differential with a bad pinion bearing or something...

So I’m injured and can only do so much, so I had an inspection done at a driveline shop. I’m pretty sure these guys were stoned because it was 4/20. I’m almost sure they left it in neutral and tried to tell me there was to much play in in my rear driveline, moving it side to side and sliding it...

This weekend upon trying to change my diff fluid in my 2000 ranger I started to strip my rear diff fill plug. 7.5" diff, I am wondering if anyone has the size/thread pitch or where I can get another one Thanks!

alright Im new well I posted once I got my 98reg cab 6ft bed 4 banger ranger im looking to put a djm lowering kit 4/5 plus c notch on it which I have sitting in boxes in my garage and looking to put on the 02 chrome top edge bumper with fogs which I just seen on this site wondering what the...

Just picked up a 97 Ranger 4x4. There is a thump when you hit the throttle. Upon investigation we found that the rear diff actually rolls back when you blip the throttle. We asked around and found this condition is not unheard of with Rangers. We were told that it could be weakened leaf springs...

I just got a 1999 Ranger XLT 4x4. I will ask a quick question now in case anyone knows the answer. So the rear axle is bent, it was in an accident. I was originally just going to replace the axle with the same type (Ratio width etc), but I want to beef it up a bit for off road use. I'm pretty...

Does anyone know if it is possible to take the innards from an 8.8 axle and put them in a 7.8 housing?? i know i'd have to change the diff cover, is there anything else i need to do IF this is possible??:icon_confused:

I have a 2004 Fx4 level ll. I took it off roading the other day and like a day later when i would go to turn left my whole rear end would clunk and jerk real bad...the only way i can describe it is like when your in 4 wheel drive the tires are gripping real tight cause the tires are working...

I just bought a used 2001 Ranger Edge 4x4. It has the 8.8" L/S 4.10 rear diff. It rides great, no noise at all on pavement. But while taking it on bumpy backroads I noticed a rattling sound coming from the rear of the truck. I have looked but can find no obvious sorce of the rattle. The...