• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

problem


  1. 98 4x4 Ranger frontend vibrating tons after bump

    Hello all, I have a (98 Extended Cab 4x4 XLT) and whenever I go over any sort of bump or seam in the road like on the highway, there is a loud thud and then the cab starts vibrating really badly... I have searched the forums but can't find what it is. The vibration is not from the motor because...
  2. 4WD wont work!

    I have an automatic 4WD in my 98 ranger. Whenever I switch into 4Wd the truck goes into neutral on all wheels. It doesnt matter what gear the transmission is in or what speed im going. Any help diagnosing the problem?
  3. 5r55e issue

    hey guys im all out of ideas tranny stopped working a while ago finally got around to fixing it thought it was a gasket so i dropped the pan only to find no surprises there. pulled the valve body and fount it was not the gasket either. so i put in a trans go shift kit and also i had found that...
  4. 1986 Ford Bronco II problems and solutions

    i have a 1986 ford bronco 2 xlt and just yesterday the power window system on the passenger side of the truck have stoped working. i can hear a clicking noise when i give it power, but it just does not want to roll up. Does anyone know what this could be?:shok::shok:
  5. New Ranger owner

    Hey everyone I just bought a 98 ranger 4.0L manual a few weeks ago! So I am pretty new to this forum thing and my knowledge of cars and trucks isn't the greatest but the Ranger had been sitting for several years and the owner would drive it maybe two or three times a year just to move stuff. So...
  6. Control Arm Replacement

    I have a 99 ranger xlt with 114000 miles on it. I ran off the road and hit a tree stump over the winter and snapped my tie rod end clean from the steering knuckle. I replaced both parts and went in to have a shop allign the truck and they said that the lower ball joints were bad. So i spent a...
  7. koths211

    99 ranger trans problem

    so I put a new trans in my 99 ranger. everything went together pretty good and fluid is full....or so the dipstick says..( checked w/engine running) put truck into gear and nothing... pulled the 2 lines off that run to the trans cooler... not pumping... I did fill the TC before the trans...
  8. door issue

    Wind keeps coming through door it's from the top of the door and the door is hard to shut it sags down some and has play in it I can move it up and down if I pick up on it. It's a 93 ranger help will be appreciated
  9. Keyless Entry Problem

    Alright, I have a 1998 Ford Ranger, I recently(4 days ago) received my new keyless entry remote. It worked for the past few days after doing to sync process, but today when I left work my remote wouldn't unlock my truck. The key unlock worked fine so I figured it has de-synced or that it had a...
  10. No power no exhaust!

    alright i just bout this 1990 ranger 4x4. plan on making it a mud/trail rig and DD. gotta lift for it on the way and new intake. but anyway, truck has no exhaust, use to be my friends and he cut it off at the manifold, so no cat or anything, so obviously no back pressure=no power. can i throw on...
  11. troubles with my body lift.

    I have a 1999 ford ranger with a 4" suspension lift and a 3" body lift. It is sitting on 33" toyo open countrys. lately i have been getting tired of leaning so much whenever i take turns. Also im getting a bunch of shit from my buds because of it :bawling: . I figure if i take my 3" body lift...
  12. Gas in the oil?

    I just bought a 92 ranger for a parts truck and the motor makes this wierd noise and won't go faster than 15 like it has no power. I pulled the dip stick and noticed it smelled like gas. I don't need the motor but would like to get it running cause the truck is much nicer than I thought it was...
  13. Speedometer help!!!

    Last weekend I went out wheeling and hit a few puddle going as fast as I could and the force ripped my VSS off the diff and when I went to plug it back in (this has happened before) the plug in the axle had been ripped out so I went the last week without a working speedo. I put in the new VSS...
  14. HID retrofit wiring? HELP

    I just finished retrofitting a set of h1 mini projectors into the stock housings of my 01 mazda. I cant figure out the wiring. The truck harness has a HB5 connector but the kit is H1 bulbs with a shutter in the projector. I am a noob at wiring and I cant figure out how I should wire everything...
  15. 1987 Ranger HELP ME

    I have a 1987 ford ranger 2.3L 4cyl Its my first truck and it needed all new head gaskets, dist cap, sparks,wires, air filt, and a few small things. i replaced all of that. i drove it for 2 months and the transmission is like: 1. Start car go in drive, moves till i let off gas and then i...
  16. cauhcons

    Front crossmember bent Hit a stone...... B4000 99

    Hello, I have a B4000 1999 and Yesterday i hit when offroading a stone right on the front crossmember... The truck feel perfect, the alignment "seem" to be good and i got no vibration at all. I am wondering if i should get the alignment check, or see a frame shop if the can fix it, or i need...
  17. Weird Problem

    HELP! I have a 2001 Ford Ranger Edge edition; it has the 4.0 V6 and a standard transmission. Just recently I have had a problem with some of the lights. The problems are: I have no light in the rear when I put the transmission in reverse. The other problem is when I hit the brakes, the...
  18. strangerst 4wd issue ever!!!

    Hi guys, I have found some more details on my problem. The manual hubs both engage, no problem I jack up the passenger side, engage the hub and spin the tire... the shaft rotates and it spins around and around and around I jack up the driver side, engage the hub and spin the tire... the...
  19. I need help asap!!!!!!!!!!!!

    i was driving to my house when i see the oil pressure gauge go down all the way. the truck stalled and stopped. i tried turning it back on but it wouldn't. i have no idea what the problem might be. please help me
  20. Alarm problem!!!

    heres my problem I've got a 2000 4 cyl ranger and when I bought the truck it wouldnt start unless you unarmed the alarm even if it wasnt armed you had to unarm it to get the truck to start. the guy before broke the keychain part of it so he drilled a hole in it and made his own keyring and in...


Top