• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.


  1. Dana 35 SLA center pin removal?

    Hi everybody, I'm working on replacing the bearings and seals in a Dana 35 SLA axle housing, but I can't figure out how to get the center pin past the ring gear! This differential has a 4.10 ratio and the ring gear is huge. Like, the pin is barely visible behind it so grinding the teeth down...
  2. Vulcan piston pin removal

    I was surprised to find no posting of this topic in the entire site, so let me write up how I did it. This is based on the vise technique shown in this video (credit): How to easily remove piston bolt without a press. I am calling it piston pin (or wise pin) as it should be. Here is an...

Sponsored Ad

Sponsored Ad