• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

maf

  1. Starting a sitting truck? Help!

    Hello! I have recently started working on a 1994 Ford Ranger. I know it has been sitting for a while, likely upwards of four years, but no way to truly determine. As of right now it is a crank-no-start engine. Prefacing this by saying this is not only my first pre-OBDII car I have worked on, but...
  2. 171-174 codes

    My trusty '96 LongRanger started thowing P0171/174 codes recently and I was finding the truck a little down on power and harder to get good mileage. Now back in my younger days, my engines alway had a "lean code" because I drove Mopar slant sixes and 2.3 Vauxhalls -but that was before the days...
  3. crs.wdp

    High idle 1991 Ranger 4.0 OHV, 1200 rpm

    First time posting here but I've been reading all the posts on here as well as other sites trying to solve my high idle. I'm running out of posts to read so I figured I'd try posting it and see if anyone has any more tips. It idles at 1200/1300 rpm. Its a 1991 Ranger 4.0 OHV Auto 4x4 STX reg...
  4. 99 2.5L, rough idol and misfiring during acceleration and driving

    This problem has been around since I bought my Ranger, but it also comes and goes, so I always end up forgetting about it but now it seems like it’s back and is going to stay. When it first started misfiring, I replaced the MAF sensor, air filter, plugs and plug wires, and it ran perfectly...
  5. 94 3.1L pcm problem?

    Hello all!, Recently bought a 1994 mazda b2300 4 cyl 2.3L. After about 2 weeks the check engine light came on and stayed on. The truck then started to bog down and have no power sometimes. (not always) I used my scanner and got o2 sensor, maf sensor, restricted egr flow, and failure in cid...
  6. 2011 ranger maf adapter

    just wondering if there is a maf adapter out there that anyone knows of that i can buy or make myself.:icon_welder: The stock air box is connected to the maf housing on the 2011 ranger 4.0l i would just cut it out if it was an older vehicle but being new i don't want to ruin any parts. ive found...
  7. 84bluebronco2

    Seriously confused by 94 Explorer

    Well a couple months back i posted about a shuddering problem my truck was having. A lot of people jumped and said it was clutch, but it ended up the clutch is just dandy :D Since then the truck has gotten new plugs, wires, coil pack, intake boot, thermostat, fuel filter, and had the intake and...

Sponsored Ad


Sponsored Ad

Top