lower

Looking to lower the Green Meanie. Have the shackles flipped on the rear for now to level things up. Want to eventually do a drop beam/drop spring combo with an axle flip/frame notch. Won't have much of a budget so used parts is an option.

Hello All, I have a 02 XLT extended cab ranger that I will be lowering 5 inches in the front and 5 inches in the back. Up front I have belltech 3" drop coils and djm 2 inch drop lower control arms but need shocks and ball joints. My djm arms didn't come with balljoints installed so I need a part...

I want my '97 to sit about 3/4" lower than stock. What would be the best way to do this? I'm not sure if I should do dream beams in the front or just do some lowering springs. As for the rear end, I've got the stock 7.5" rear end in it right now(probably only holding up because it doesn't have...

I'm a new member her and would like some help with wheel backspacing and offset. Before you say there's an article on backspacing for this, I know. I'm about to buy a 96 2WD XL Ranger after my next paycheck for $300. Sure there's problems, but I couldn't care. It needs tank straps, leaf spring...

I am looking at a 2007 Ford Ranger FX4 Off-Road SuperCab 4dr 4WD. It has the original split bench seats. I really like it but my only issue is head room. I have reading through various forums trying to find out about replacement seats that will sit lower thus creating more headroom. I have no...

so i am in the process of removing/replacing the passenger side steering knuckle on my 1993 4x4, i have the tie rod end out of the knuckle, the upper ball joint is completely free, and the castle nut is removed from the lower ball joint, so the whole knuckle should drip right off. but it WILL...

I hope someone can help me. I have a 1992 Ranger 2WD 2.3L 4cyl and I believe it has a Dana 35 axle (pinch bolt). I am in the middle of replacing nearly everything on my front suspension (bushings, leveling springs, shocks, ball joints, tie rods, rotors, calipers, brake pads). I ordered new ball...

I hope someone can help me. I have a 1992 Ranger 2WD 2.3L 4cyl and I believe it has a Dana 35 axle (pinch bolt). I am in the process of replacing nearly everything on my front suspension. I ordered new ball joints but I inadvertantly purchased the 4wd MOOG model numbers from Rock Auto instead...