Hi guys,
I'm running down low on ideas/solutions to solve an electrical (wich I believe to be a serious ground fault) problem on my 98 B-4000 4.0L (Manual transaxle, 4X4).
Any help will be appreciated.
Let me start by the symptoms:
While driving at low speeds in the woods at night coming...
I'm new to this forum so if i'm in the wrong place i apologize.
I have an 89 ranger 2.3l manual. The other day i was idling at a stoplight in neutral and it just died. didnt seem to make any strange noises or jerks, just like i had turned it off. wouldn't start after that. Ran EEC test only in...
I bought a 1999 B3000 the beginning of September. It has 15x8 pacer sawblades. I love the rims! they clean up real good with steel wool and look good except the ring of RUST. 1 of them has hardly any 2 of them are okay and 1 is getting bad. its not just surface rust it has eaten through the...
I want to build a boss 302 Ranger but honestly have no idea what transmission to use. I was wondering if anyone could give me some advise on what would be the best way to go. I'd like to use a 2005-2007 Ranger.
I want to build a boss 302 Ranger but honestly have no idea what ranger to use. I was wondering if anyone could give me some advise on what would be the best way to go. I'd like to use a 2005-2007 Ranger. Basically what I need to know is; can the 5 speed manual transmission that comes standard...
ok guys im stuck. i bought a 2wd ranger i got it for a great price for the condition, :offtopic: but anyways i want to lift it and im not quiet sure what im doing as far as the lift kit. there was a 4x4 ranger that was lifted i just happened to see a few days ago so i bought the kit off it. ive...
Hey guys! I'm back with some serious 4R44E automatic transmission troubles. My truck is a '95 Ranger with the 2.3l and a 4R44E trans. On Sunday I was driving home from my lady's house and just a mile or two from home I went to give the truck a little gas while going 55 and...NO!!!! The trans...
Hey guys! :) I'm back with some serious 4R44E automatic transmission troubles. My truck is a '95 Ranger with the 2.3l and a 4R44E trans. On Sunday I was driving home from my lady's house and just a mile or two from home I went to give the truck a little gas while going 55 and...NO!!!! The trans...
alright guys, i've got a good one for y'all. i've got a 93 2wd 3.0 with a 5 speed. bought it a few months back from a woman who said it has "a miss", so i knew it needed work going into the deal. replaced all the basic ignition stuff, and even fixed the 02 sensor wires on the passenger side that...
HELP !!
I'm swaping from my 89 Bronco II 2.9 to a 93 Explorer 4.0. Can anyone help me with the wiring change ??
You can e-mail me at dapatt2002@yahoo.com
okayy so heres my story and i really need help with all the issues i got goin on .. okay i got a 1989 ford bronco II v6 2.9 4x4 and it drove fine and everythings been good to me besides a tick in the moter but then a while back i was driving home and itd act like i was running out of gas and...
does any one know if a 2000 ranger with standard pinion will work for my 1996 with a high pinion... both splines, diameters, size, and dana35 ifs all match up...also both are reverse rotation... so is the only difference the position in carrier/case????? HELP
Hello all.
I've reached the point where I really need to do a tranny swap on my 89 XLT Ranger. I've priced having the stock tranny fixed and it's way beyond my financial reach ($1500 or more depending on what needs repaired). Basically at highway speeds, the truck is shuddering. When I took it...
? really it is
My truck is a 5 spd small 4 cylinder with fuel rails
lately is been continuing to rev like the throttle is stuck ( but its not of course)
but get this...
it stays reved up untill i come to a complete stop! ???
if i am rolling it will still stay reved up like i was in cruise...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.