gears

There are a few charts out there showing the RPM’s that you run with certain axle gears with certain tires at a given speed. I used one of these such charts from one of the posts I stumbled across on this website a long while back. Sorry, I don’t remember where I found it on here. I got tired...

Need gone Ford 7.5 lock right locker by power trax 150

I have a 98 ranger, with a V6 4.0L. I recently upgraded to 33s from the stock 215s, and the acceleration / MPG is horrible. I mostly drive side streets, and was planning on upgrading to a 4.56 gear ratio from the 3.55 stock ratio. I was wandering how to do this, and what to buy. I do not want to...

i have an 85 ranger 4x4 2.8L 5sp with a 4in suspension lift and 31s under it. My only problem is that with the stock gears the truck is slower and doesnt do so hot on the highway either. she struggles to stay around 55 floored and even cruising the town i run out of gear fairly fast. Id say i...

i have a 1986 ranger, 2.3l, 4x4, 5 speed reg. cab and shortbed. its pretty light (i can pick up the back end of it) i think i have 3:55 gears(stock) but i need some new tires. i can get a great deal on a set of 32x12.50s, or a good deal on a set of 31x10.50s. which would be better ??? i do alot...

my 83 ranger has been giving me issues since i pulled the transimission and replaced a couple parts. nothing was done to the transmission, the rear main seal was replaced and the oil pan gasket. but ever since the trans was pulled out, it has been very difficult to get the truck into first...

Ok, so I've got a BII, soon to have a 4" lift and 33" swampers. Went wheeling lasr weekend, ended up high centered on a rock and sliced my Driveline in half. So, bigger tires time! I know my little 2.9 and 3.45 gears aren't going to churn those 33's very well so I started to think about dual...

i got 33/12.50 on my 4.0 4:10 geard ranger and only average 12-15 in the city and 15 on the highway is this because i need to buy a speedometer calibrator?

I have a 2004 Ranger with under thirty thousand miles on it. It started to make a clanking sound somewhere underneath. I inspected it and it sounds like a little piece of metal that is flying around my bell housing, or gear box. I don't know what is making this rattling but it seems like...

ok i just bought my ranger with a blown up dana 35 in the front(full of mud and no bearings left). I've bought the 4.56 r/p front/rear with master install kits. what i need to know are the dimensions for the slinger shim-inner bearing on my 1996 ranger ... i'm a machinist and plan to build one...

howdie. i wanna make this short and sweet. i got a 96 ranger 3.0l v6 sohc 2WD. 4 inch rc lift. 33 inch all terrains. i wanna lock the rear end. should i re-gear to somethin higher. if so what ratio. 4.10s? 4.88? thanks:icon_cheers:

I've decided my Explorer will never see the light of trails. I'll buy another RBV for that. Laugh at me, hate me, I want a parking lot pounder. If I wanted to run say something like a 31 in place of my P235-75R15, could it be done acceptably with 3.73's? My truck has 3.27s right now and they...