• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

fuel pressure

  1. Cranks no start after checking fuel pressure.

    I checked my fuel pressure with a new gauge I just bought but after using it my truck won't start. It ran fine before so im wondering if I bumped something or if there is some sort of safety device that engaged preventing it from starting. When I turn the key I can hear the fuel pump engage...
  2. 2.3L ('83-'97) Fuel Pressure Bleeding Down

    Hello all, I'm currently in the middle of a distributed turbo 2.3 conversion from a 1988 Thunderbird Turbocoupe into my 1991 Ranger, which had the EDIS 2.3 stock. I am running into a bizarre issue where the fuel pressure is bleeding down after letting the fuel pump prime the engine. I have done...
  3. No Fuel Pressure and No Start Condition

    I have an 86 Bronco 2, It was unable to turn over and the mechanics had told me there was air in the fuel lines. after getting it back it was parked for 4 hours and then would not start up again. Am I correct that in the on position the Schrader valve should produce 40 PSi of fuel pressure...
  4. Rough Under Load - Fuel Smell - No Codes

    Truck starting jerking a little a few days ago at highway speed and then continued even at low speed. First thought was bad fuel pressure or blocked fuel filter. While driving/under load: Heavy vibration and sometimes jerks/bucks. Feels drive train related. At idle or rev up while in...
  5. JavaG66

    Fuel Pumps Expertise Sought

    At the Schrader valve on the injector rail: KOEO- 5 psi Idle - 30 psi Faster- 28 psi Truck cranks up and drives fine, does not idle well, is weak/misses at low rpms and smells like i'm just shooting raw gas straight out the back end. Anything above an idle it seems to run fine. So in the...
  6. generic

    Replacing 1996 4.0L upper intake gaskets & injector seals

    I need to replace the fuel-rail-to-lower-intake gasket(s) on my 1996 4.0L OHV as they have begun to get sucked into the front and rear pair of intake ports. Mine is the plastic spacer (~3/16" thick) sandwiched between 2 thinner gaskets (paper I think, don't have them off yet). I have the intake...
  7. 94 v6 4.0 runs for 30s to a minute before stalling

    Had a bad cooling system leak. Lot of white smoke coming out of the exhaust and. Cylinders and oil flooding wIth coolant. Gradually got worse running really rough. So I changed head and intake gaskets this past weekend. Now runs strong with no smoke. For about a Minute before stalling out...
  8. Fuel Flow Problem

    A few months ago I swapped out the fuel pump as well as the fuel filter due to a no start situation and a verified no power to the fuel pump. Ever since this time, when I get below a 1/4 of a tank I have problems with idle when coming to a stop. Sometimes, it will die and other times drop to...

Sponsored Ad


Sponsored Ad

Top