I have search the forum, and came accross Jims post:
My question is regarding the front end bumper. Are all the 98-2011 direct bolt on fit?
so I’ve I poked around on the forum. And it’s probably on here some where. This is the first forum I’ve really engaged on . Does anyone have bumper plans tubular preferably pic for attention
97 Mazda b4000 manual trans
Extremely clean picked up from the original owner runs like a champ
The front bumper of my 99 ranger xlt is bent, and i'm looking for a cheap or diy fix, not a cheapskate but parts are expensive and I can do it myself I will. I've wanted a custom from bumper for it but never knew where to look for one, that being the alternative to fixing it or diy fix it till I...
So I got into a bit of a fender bender yesterday (4/21/16) and I rear ended a sedan, I think it was either a dodge dart or chevy malibu or something of that nature. Anyway the damage to my truck, I drive a 99 Ranger XLT, was minimal except for the driver's side of the front bumper is bent down...
Hey everyone! I was wondering if there was any after market winch bumpers that were for other vehicles like jeeps or chevys that would fit on or close to my 1994 4x4 ranger super cab. And no, I don't have a welder yet to make my own bumper.
so far as i can tell (i havent managed to park beside one or measure one yet) but a 1st gen xj is the same width. i found a winch bumper for an xj from rough country ho hard would it be to make it fit my bronco
so im wondering could the bush bumper wag makes for the 98-00 ranger be made to fit my 93 so far as i can tell the bodywork is very similar and swapping to a bumper from a newer truck is no big issue or does someone make a bush bumper for a gen 3 ranger
Hi, I am new to the site and I was wondering if the front bumper from an 06 Ranger would fit a 2002? I know with F150's 04-05s have a different mounting set-up than 06-08s and are not compatable, but they are all still the same generation/body-style. Thanks for any help, quick replies would be...
I have a 93 Ranger and Im looking to get a rear tube bumper like this one.
The problem is no matter where I look, I can only find them for jeeps. I was contemplating on having...
Original Poster: ME!
Difficulty: 3 out of 10
Time to install: +- 1hr
Disclaimer: The Ranger Station.com, The Ranger Station.com Staff, nor the original poster are responsible for you doing this modification to your vehicle. By doing this modification and following this how-to you, the...
this is probably a dump question and i'm pretty sure i know the answer but before i go spending money i want to be sure will 93 to 97 ranger bumpers fit on my 96 b 3000 the frams are supppost to be the same so they should fit right?
just wondering if there is anybody out there that has made this like what some of the F250 have... i have a winch that goes in a trailer hitch that came off a hummer H2 i would like to use it on my truck but i wana keep the stock bumper any ideas? Picture plz if u have this set up