Problem: Warped/bent/deformed backing plate on 94 explorer axle.
Preferred solution: Replacement backing plates shipped to my house.
The issue i am having is trying to figure out what fits. Every search i make winds up with 9" stuff. I don't want to switch to disc as i would have to buy a kit...
Brakes were acting complete normal, no abnormal sounds, abs functioned. On my way around town earlier this week, the pedal just went straight to the floor, and now the brake will grab when the pedal hits the floor. :annoyed: When they grab, it make the truck bounce, almost like the brakes are...
hey i recently got an 92 explorer rear to install in my 89 ranger and it was missing the parking brake lever on one side is there any place i should look to find one? thanks
Anyone,
I recently (within last week) bought my first Ranger. It's a 1999, 3.0L V6 4WD. Today, after running without any obvious noises, the truck as developed a fairly loud and constant squeak from the rear that stops only when the truck is no longer moving. Engine RPM has no...
Hey Guys & Gals,
My 97 ranger 4wd w/ manual locking hubs...front rotors are beyond WARPED!
I am under the impression that to replace the rotors you have to take the whole hub apart because of the Manual locking hubs?
If thats the case how hard is it to do?
When I press on my brakes, my left rear wheel locks ups for about one to two seconds, then releases. Also, it takes alot of brake pressure to get the vehicle to stop. The ABS light is NOT on, and new brakes/rotors/drums. Any ideas?
2001 Ford Ranger 3.0(not flex) 2WD Automatic Trans
hi guys
well i just did a brake job on my 96 b4000 4x4, that went good, while doing the brakes i also replace the rotors,drums,rear brake cylinders and the ujoint on the drive axel front pass.. side.
here is the issue abs light comes on as soon as i start the vehicle and stays on. also after...
I have a 1990 Ranger 2.9 L the rear anti lock brake light comes on between 35 & 40 MPH and stays on until you turn of the ignition the in again between 35 & 40 MPH, I have done a complete from and rear break job, replace the rear speed sensor, the vacuum booster, master cylinder the rear control...
I have a 93 with 10" drums and I'm trying to replace the shoes and springs. After I put everything back in place I had my wife press the petal only to see the shoes not move. My question is would I be able to see the shoes spread when the brake petal is applied? I see them spread when the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.