• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

bearings

  1. Drivetrain squeaking/chirping diagnosis

    I just noticed a squeaking or chirping sound coming from the rear of my truck, me and my dad did some testing. When going slow the chirping was slow, but as we accelerated it got faster. But when we pushed the clutch in, the noise stopped. There is no problems with driving, shifting, etc. A lot...

  2. What's needed for a TrueTrac install?

    Hi all, I'm installing a detroit TrueTrac in my 7.5" rear with 3.73 gears... What all would I need to buy to do this? I know I need carrier bearings and races- Do I need anything else like shims? Also, what is the best source for these parts? Thanks in advance!!

  3. 87 ranger xlt hub issues

    hi i recently bought an 87 ranger xlt 4x4, was replacing the front passenger side bearing and notice the needle thrust bearing, bearing spacer, and the axle shaft spacer are missing. mine are auto locking hubs WITHOUT an inner and outer spindle nut. the spindle nut on there is a hex nut, not a...

  4. Fm145 replace bearings

    I have a fm145 in my 87 broncoII, and it was making a lot of noise in all gears other than 4th. So I figured bearings and pulled the trans. Have not broken the trans down much yet but can def notice the slop in the input shaft. Found bearing, seal, gasket, and synchro kits and am planning on...

  5. 96 Rotor Removal

    96 Ranger Super Cab 3.0 I'm pretty sure I have a Dana 28 in a 35 Carrier. I'm trying to replace the wheel bearings. It appers to me that the caliper mounting plate (anchor plate) must come off to remove the rotor. First off, is this true? Assuming it is, I have not been able to break the bolts...

  6. driving without front half shafts

    Alright guys, got a quick question for anyone with experience with the newer style (2002 4wd) unit bearings. im working on getting all the parts togethor for a SAS and on tuesday my passenger side cv joint ate $h!t :bawling: . The unit bearings were replaced about 6000 miles ago. Is it safe to...

  7. Please help! Wheel bearing problem.

    Hello everyone! I was recently replacing my front brakes on my 03 Edge (with a haynes manual) and I had no problems getting the rotor and caliper off, but sure enough I couldnt figure out how to get the Inner grease seal out of the old rotor of for the life of me! The haynes manual says just pry...

Sponsored Ad


Sponsored Ad

Top