bearing

Hi everyone. I'm currently rebuilding my rear axle and was checking the pinion bearing fit. The lower one needs to be pressed in, that was clear to me, but what about the upper one? When I handfit the bearing, it doesn't slide down on the seat. It seems that it'll have to be pressed in too. Not...

I have a 2003 5.0 ranger edge. I swapped in the T5 and used an older ranger master cylinder and universal slave. To use the older ranger master I had to drill holes through the firewall to mount it since the 98+ rangers master snaps into the pedal assembly itself. That lasted awhile but it...

Hello everyone, I am new to the forum and have been poking around on here for a while trying to come up with something to match my issue. With no luck and tired eyes I am posting for some advice. I have an 02 B2300 2wd that I bought about 6 years ago. One year in and the 3:73 rear end went...

my ranger has some bearing noise in the front while driving in a straight line, there is another roaring sound when turning left, how can i determine if its a wheel bearing and which one or if its a cv joint or pinion bearing?? I was also trying to find out if there are bearings where the...

I went out to change the front passenger side wheel bearings, everything came off just fine but the outer bearing was completely shot.. all that was left was the race. Pretty sure it is supposed to just pull off, but it wont budge. Tried beating it with a hammer, any ideas of where to go from...