auto

On the way to work the other day, I started to get a pretty major shudder in the driveline. I've since noticed that it will only do it right after it has shifted gears and it's low in the RPM range, while you're applying more throttle to try to accelerate. It's a major shudder and will rock you...

So, I've already completed this swap, after taking many months of time to gather resources, do some homework, and jump into the grease pit but it was worth it. My vehicle is a 2000 Ford Ranger 3.0 V6 FFV 2wd (non-edge) I did not make use of a donor vehicle for this swap. Here's the information...

Hello everyone i cant find any info on doing this. Its not for a ranger its for another project. What i need to know is can i bolt a 2.3 auto tranny from a 2001 to a early 90s 2.3 that had a manual and what other parts id need? Ill be using a floor shifter so if if anyone could help i appreciate it.

Im trying to convert my 89 2.9l Auto ranger to the 4.0. I have a motor out of a 1990 with wire harness and ECU. As of rightnow having issues tracking down a good transmission out of a 4.0 ranger. So my question is can i keep my 89 auto transmission and just get it rebuilt with stronger parts to...

I'm in the process of timing cover gasket replacement and now I need to replace the oil pan gasket. (2002 3.0 4wd Auto) I've dropped the front axle but still can't get the pan all the way off. I've been told you can loosen the transmission bolts and slide the transmission back a half inch or so...

Hello ladies and gentlemen. Vehicle: 2002 Ranger XLT, 4.0 Auto, 161K, electronically shifter transfer case. Me: College educated shadetree mechanic, plenty of engine experience, little transmission experience (I know how to check the fluid, does that count? :P) Short version: I'm looking for...

I just bought a 92 ranger for a parts truck and the motor makes this wierd noise and won't go faster than 15 like it has no power. I pulled the dip stick and noticed it smelled like gas. I don't need the motor but would like to get it running cause the truck is much nicer than I thought it was...

I had to put my project on hold for several weeks. So many things came up so I couldn't work on it. But I'm almost done!! I got the carb rebuilt, put back on and the engine runs great. However, I am still at a loss about this automatic choke. I cannot tell if it's working or not. I know that...

I have a 2000 Ranger w/ the PVH 4x4 system, the truck was made before 06/2000 so it does not have the live axle set up. It also has 4 wheel abs, fyi. In December I changed both hub bearing assemblies, left and right sides. While I was changing the hub bearing assemblies I noticed the steel...

Hello all. I've got a 99 Ranger 4.0L 4x4. From what I can tell, the transmission code on the build sheet on the door jamb is a 'D' which translates into a 5R55E. There no service lights being illuminated on the dash. Please correct me if I am wrong. However, I am not sure how I have a 5...