-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
94 ford ranger
-
2.3L ('83-'97) ‘94 2.3L starts and then stalls.
Truck will stall immediately after starting. Unless I unplug MAF. Then it will run solid for a minute or two…until idle goes rough and then stalls out. Looking for advice. — Current Knowns: *KOEO Code Pass from Ford OBD1 scanner. *Engine smells like burnt rubber when trying to start, not like...- ororion
- Thread
- Replies: 7
- Forum: 4-Cylinder Engines (1983-2011)
-
LS Swap
Started life as a 2wd 94 Ranger Splash extended cab with a 4.0 and an automatic. The engine and trans have been removed. Then I swapped in a D44/9. Right now I am working on cleaning up the under hood wiring, by removing anything I don't need. The way I started looking at it all I needed to...- nightstalker00
- Thread
- Replies: 4
- Forum: Other Engine Swaps