Hello,
I am currently looking at replacing my engine on my 1993 manual 4x4, 3.0 V6 ranger. I'm hoping somebody could help on what engines from what years will be a direct swap. Just looking to get the truck running with hopefully no work, just an easy drop and plug in engine. I've heard that...
Hey guys. I have a 2005 ford ranger edge with the 3.0 in it and wanted to jump up to 31" tires. I do 50/50 street and off road (dirt) and wanted to put bfg R/T tires on the truck. The stock ratio is the 4.10 so I was wondering if that would be fine for putting on 31x10.50x15? How would that hold...
I have a 1998 Ranger with a 3.0V6. It has 187,000 miles and has always run well. Last week I noticed a weird vibration and noise while driving home. When I got home the truck would barely run and had a very bad misfire.
I took it to Advance Auto and ran their computer on it. It showed...
Last Monday on the way to work the Ranger shut off on the freeway. Had it towed home and looked it over. The rotor wasn't turning when the engine was cranked. I pulled the distributor (have never done this before on any vehicle) and found two worn teeth on the drive gear. (The bushings are...
My 2000 Ranger XLT 4x4 currently has the 3.0L-V6 in it but I'm going to need to replace it soon (rings and compression issues and 200k+ miles), my question is this: should I just replace it with another 3.0 or upgrade to the 4.0? This is my daily driver and needs to be reliable. What do you guys...
okay so i have a 08 sport, it has a 3.0 engine, im not that inclined with parts and things....so my question is, what exactly can i do to my engine to give it more horses, could i turbocharge, or supercharge it, i just need some help, so any comments would be great
I have: 1998 ranger W/3.0 automatic W/OD RWD
The problem (other than me): I retired, moved to the high desert, hit a rock, dented the trans/pan exactly where the intake hole is for the filter. this caused the trans to start slipping, yadayada. I dilligently researched the identification of the...
My 93 died on me driving down the road. No spark detected, installed a new coil and still no spark. I read around the forum and got info about the cam sensor and the ICM. The problem is I don't know how to test these components for failures. I have power to the coil but the other cable gives
me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.