Installing new injectors and cleaning the EGR port
Need torque specs for reasembly
1) Upper intake to lowere intake
2) throttle body to upper intake
3) EGR valve to upper intake
Cheers
Carl
1985 project truck 47k miles. I was having a slight shutter when breaking so I pulled the front calipers to clean and lubricate the brakes. I did not brake the lines, just collapsed the piston. After reinstallation I had a very soft pedal.
Before compressing the pistons I had removed...
1985 2.3L EFI
Engine code 31 - EGR Valve Control Sensor Fault
I just replaced the EGR valve in an attempt to clear this code. I did not replace the EGR position sensor. This was a fail, I still have the code 31.
I guess my next step would be to replace the sensor but I'd like to be sure I...
I've concluded the valve seals in my Ranger must be replaced. I'm going to do this two weeks out but need this special tool to do the job. For specialty tool
T74P-6565-A here is a link
http://*******.com/Special-Valve-Spring-Tool
Cheapest one I could find. I hate to buy it for a one...
The sticky thread at the beginning of this forum does not provide the nominal compression for this engine.
Just tested mine with the following results
Dry Test
Cyl = PSI
1=165
2=160
3=158
4=175
Wet Test
Cyl = PSI
1=260
2=270
3=265
4=250
I need some specs to tell me if these are in range...
1985 Ford Ranger - 2.3 EFI. Debugging low fuel pressure. This component is inline between the high pressure fuel pump out and the fuel rail on the manifold. It is not shown in the manuals that I have. See the attached photo.
I would guess a check valve, but I can't find any info. Anybody...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.