Search results

I recently changed my clutch in my 94 ranger and i changed the trans fluid while i was at it. I put dex/merc in it and in the mornings when its cold (10-20 degrees) the trans shifts fine but on my way home from work in the afternoons when its warmer it tends to grind going into forth. Should i...

I have a 94 ranger 4.0. The motor has no power on takeoff at times and idles rough. I have replaced the crank sensor, tps and mass air flow sensor plus ran a pipe through the cat,new fuel pump plugs and wires within 4k miles. I'm throwing 157,159,177 codes. thought the exhaust was stopped up but...

i have a 94 ranger 4x4 and i just got it aligned and i was wondering if the specs looked correct cause some of the specs aren't within the vehicle spec such as cross caster and front left camber.

I have my bed off and just changed my leaf springs have been getting hesitation on start up wot and idle fuel pressure is on the low side so I'm changing the pump while I'm there. So in the morning I'm going to the parts store to pick one up they offer delphi or airtech. I have reads bad things...

I wasnt sure where to post this but here we go. I am getting vibration at speeds about 45. It feels to me like its coming from the front. I took it to get aligned and the mechanic told me that my front u joints were bad and that i needed to replace them before it can be aligned. So I'm going to...

So im back again with a strange issue with my 94 4.0 ranger. Everything is going great runs good warms up good no issues. Then I turn it off........ Wait about 10-20 min start it up sounds great no issues. Let out the clutch give it some gas, it stumbles. This only happens for a short period of...

Every diagram I looked at for this year says I have an egr and a evr but I cannot locate either. Here are the pictures that follow my vacuum except for the canister side I know that is right. . Sent from my iPhone using Tapatalk

I have a flat leaf on my passenger side and I think it needs replaced I looked in my door and can't find anything on auto zone or advanced with the same rear spring code they only have b or u and it appears I have x I will post a pic of my leaf spring to see what you guys think tomorrow...

I currently have a 94 ranger 4x4 4.0. This is my first 4x4 truck and i have recently took up to mudding and im a novice to say the least I have been 3 or 4 times but i enjoy it to say the nonetheless. I want to use my truck to go mudding and buy something else for a daily driver. I have been...

I have a 94 ranger 4.0 ranger. putting a 4" rough country lift on it in a few weeks and looking to buy some mt tires. truck is just going to be used for off road. I currently have 265x70x16 on it what size could i go up to? I was thinking 33s or 35s and would this put to much strain on my little...

Almost every time I go mudding my truck will die when I hit a little water. Usually I'm in second gear with it all the way to the floor and the end result is me getting stuck not from spinning either it just stalls out. Any1 know a solution or as to why this is happening? Sent from my HTCONE...

I have a 94 ranger and I have recently been having issues with my lower radiator hose pushing itself off. I replaced my rad cap cause the lower hose was collapsing and now that the hose is not collapsing my hose us coming off or loosening. Any ideas? Clamp and hose and new and yes clamp it...

I have replaced all cooling components and just got my air pocket out and I was wondering if this was a normal temp. It stays below n and if it's really warm out it might reach between n and o but stays at n or mostly right below n. Idk if it's my new water pump and radiator working to good or...

I have a 1994 4.0 4x4 ranger. It has been crazy cold here around 20 highs. My cel would come on for a moment at start up and then go off so I figured it was just the cold temperature. Today it was around 60. I finally got my air pocket out and shut it off for about 5 hours before driving it...

I have a 94 ranger 4.0 4x4 with a 5 speed. I think my clutch is going out or I have air in one on my cylinders master or slave. What are some signs of these problems? My clutch used to be in the middle of the pedal but lately it is getting near the top and it's easier to push than when I...

I have a 1994 ford ranger 4.0. I have replaced about everything i can think of coolant wise. new radiator, water pump, all new hoses, thermostat, radiator cap and even coolant temp sensor.( broke it replacing head gasket) I cant get the temperature gauge to work. it stays on cold even after the...

Ever since I changed my head gasket my temp sensor has slowly stopped working. This morning it was around 25 degrees and my idle is all messed up when cold. It will go from little over 1k to 750. Would this be because my engine temp sensor isn't reading normal when truck is at operating...

I have a 1994 ford ranger and im wanting to put a sub in the back of my ranger. I'm thinking about putting it on the driver side behind my seat seeing how no one can ever site behind me anyways. im pretty sure a 12" would fit no problem but has any1 ever seen a 15" a ranger or is it just over...

I recently changed the head gasket and after about 2 hours of driving time I'm still having this problem with the temperature. It takes forever to move off cold and it will go to either normal or go to run hot then go cold. And it keeps doing this. The water pump thermostat and all hoses have...

I have a 1994 ford ranger 4.0 4x4 truck stock suspension to my knowledge. I just had my truck in my grandpa's shop getting the head gasket replaced and i noticed the bed appeared to lean to the right. My first guess is that the shock is bent but im unsure if this is common or not. the tire...