Hi everyone. I've looked all over and can't find a specific size for my hard brake line going from the RABS Valve to the rear... I know the fittings are 2 different sizes on each end. One of which is 3/16, but can't figure out the other one. I would run to the parts store and check right now...
Just finished the 4" lift on my 1990 ranger xl 4.0L V6. Turns out my front brake lines are too short now, I was kinda expecting this to happen since there wasn't much play in the first place.
Question is how do I extend them without buying the stainless lines from skyjacker. Can I throw some...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.