i have and add a leaf and it raised the rear end a little and want to bring the front up. i have a 98 4x4 any good ideas to get some lift? i know torsion bars but are there any other possibilities?u
http://store.summitracing.com/partdetail.asp?autofilter=1&part=RAN%2DRSX17030&N=700+4294924677+4294908331+4294907827+4294919396+4294881874+115&autoview=sku just purchased these will they go nicely on my truck to replace my beat stock shocks? and maybe give me some stiffness.
im planning on bolting my split bench seat brakets to a set of bucket seats i have. what type of bolts should i use for this? like how thick and just a nut and bolt? pictures would be sweet.
thanks
I would like to make my rear end a little tighter so that when i pull trailers my rear doesn't drop. Anyone know good ways to do this with out having my rear end get a 3 inch lift. maybe add-a-leafs or explorer leafs? will those give me lift?
i have a 98 with the red, white and yellow lenses i want to replace with the newer style ones that have only the red and white. let me know if they will fit or not?
this was on youtube. http://youtube.com/watch?v=qyfZi7ieK_k
I have never seen a 4 door before now. I new the suicide door one but not full door. Enjoy guys.
how much volume do you gain when you take out all the bends in the pipe after the muffler that brings it over the rear axle and just dump it before the rear tire.
Ok so my friend has a honda prelude and honestly is obsessed, has access to 2 of there seats. i was looking to get rid of my 60/40 shit split and would like these racing style seats. Problems. on the lude seats the tracks are 16 and 3/4 inches apart where as ranger tracks are more or less 14...
This may be a dumb question but, I currently have 2 halogen fog lamps and my sub woofers amplifier both tapped off my battery. The fogs are wired with a relay taping the battery and the headlight wire and the amp is directly off the battery with a inline fuse. I plan on putting two 100 or 130...
i want to install an oil pressure gauge in my 98. can some one tell me where and how to install the sender? also where should i tap for the gauge to get power?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.