It runs fine. Did notice the radio turns off when using the right blinker. And left turn signal indicator lights up when you pull on the blinker lever. And the 4x4 and seat belt light come on with left blinker. Pulled the cluster apart and found some burnt resistors and power going through...
Just bought an 02 that needs some work. The instrument cluster is dead. all of the lights in in illuminate, but none of the gauges work. Not even the odometer. No warning lights, no 4x4 and I cant find a pin out for the cluster and was wondering if anyone can help
Got a B2 a while ago, Ran like crap but the price wqas right. Got it home found out the Fuel system was full of mud. Replacxed Fuel Filter, Pump and used pump to flush out the lines. Still ran like crap. Checked compression and found that it was only &0 PSI all the way around. Had the heads...
I am putting a 2.9 together and turned the engine over and this fell out. I have no clue where it came from or what it is. Need to know what it is. Trying to get this engine put back in tomorrow. It is about 10" long and the ends are exactly the same
. Got B2 with a bad engine for dirt cheap. Now I can get a 3.0 out of a Aerostar for next to nothing. I know I will need the Computer, wire harness and a different tranny. Just checking if anyone has done this swap.
Checked the oil in my new B2 and noticed that it was super thin. Changed the oil and now it has a slight Knock at around 2000 RPM and above. Sounds like a bad bearing somewhere in the block. Any ideas?
This video is from before the oil change
I just got this yesterday and was going through the engine compartment lookimg for my lack of power issue, found this.
My question is, where are these wires supposed to go?
I just got the cleanest B2 I've ever seen. :yahoo: It's an '89 2WD automatic.
Stole it for $300 and a shotty. That's the good. The bad is it has no power until it gets out of third gear. Then it's all good. I know it has the 4R44E tranny. Any hints on this issue would be great.
Found a B2 for $700. Guy says it needs a throw out bearing. Should this be a deal breaker. The truck is 50 miles away and I don't want to waste time or money going ro look at it. From the pics it's in decent shape.
I don't have it in yet but plan on a 3" body lift, roll cageand mount the rad in the rear to make things a little easier. Still getting parts together. I bought the engine with a 3speed tranny. I'm researching if I can use this tranny for 4x4 but there just isn't alot of info out there and havnt...
I am currantly working on putting a 300I6 in my B2. My question is what axles would hold up best for the best price. I know that the D28 and 7.5 that are in it now are going to explode as soon as I put the skinny pedal to the floorr.
I rolled my B2 and the 2.8 has finally decided to clunk out on me. Since then I have been trying to decide what to do. Scrap or rebuild? I couldn't decide until I saw a 300 with trans for $100. This weekend i start on the tear out of the 2.8 and all the emissions garbage.
I need some advice on...
I recently acquired a 300I6 with a three speed manual and I am trying to find a transfer case for it. I need to know what the best t-case would be to put behind this thing
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.