I am doing a head gasket job on a 2000 4.0 and would like to remove the 2 guide dowels that align the cylinder head to the block. I've tried to twist them out with some pliers with a piece of rubber to grip it, no go. Tried tapping with a small hammer, they don't budge. Is there some trick to...
2000 4.0 4WD....85k miles. Getting ready to replace the head gaskets. I'm concerned about getting the new TTY headbolts into the yield zone. Should I lightly oil the headbolts before installation? Also, what about a washer on the headbolt to avoid galling. Would that affect the torque readings...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.