I am reposting this in general seeing if I can get some info on this
http://www.kijiji.ca/v-heavy-equipment-parts-accessories/ottawa/perkins-diesel-a4-211-engine/584075577?enableSearchNavigationFlag=true
I have looked up a4 211. I can't find it. I am not a diesel person. I know how they work...
http://www.kijiji.ca/v-heavy-equipment-parts-accessories/ottawa/perkins-diesel-a4-211-engine/584075577?enableSearchNavigationFlag=true
I have looked up a4 211. I can't find it. I am not a diesel person. I know how they work sorta. And that's about it.
so whats this out of and its it a...
My 1997 ranger 4x4 locked up its engine while I was driving home last week. pronounced Dead. While what exactly broke inside the engine no one can tell but no one can turn the engine over even with a large bar on the crank. :sad:
I have found a 1999 ranger 4x4 with the same engine 3.0 but...
Hey people. My 4x4 up and stopped working last night. All that was occurring was bad weather. 1998 3.0 4x4. The dash light 4x4 flashes the 4high 4low between 4 and 6 time about every 2 minutes.
I don't even know where to begin on this system.
Hello peps.
So a month a half ago the truck was stumbling a tad and then a injector went down.
Having found the dead injector and replaced it truck of course ran much better.
But. at low rpm, not at idle but between 1600 and 2100 it will tend to misfire not enough to light the CEL...
Howdy peps. Truck started running bad. doesn't throw a code but I pulled p0302 anyways.
which is great since I already knew it was misfiring anyways.:icon_thumby:
I am currently at work I can't work on it for another few hours. its got spark, the plug ive pulled and it seems ok...
So after owning a 1992 ranger(exploded transmission) a 1993 ranger(exploded transmission) then a exploder (transmission did Not explode contrary to name). and 2 cars in between
Id like to announce that I have returned to Ranger ville with a 1998 ranger xlt 4x4 flare/stepside with the 3.0...
Howdy peps.
Is it possible to take the spider gears out of a open 8.8 from a explorer with the 31 splined spiders.
And install them into a limited slip carrier in place of the 28 spline spiders?
Someone is selling parts off of a 1995 explorer in my area. including a engine and transmission.
What would be involved in making a 1995 explorer auto transmission work in my 1992 ranger. other then of course bolting it on.
both are 4.0's
howdy peps. I am going to be swapping my cruise control out of my 92 ranger and into my 93 explorer.
First up and what I have done so far, I swapped the steering wheel and those slider pins for the back of the wheel and promptly discovered that while the rangers harness plug for the horn and...
Well after some consideration. I have decided that my 1992 rangers second auto transmission failure that the cost to repair the transmission would be greater by far then to just get another vehicle...
The wonderful world of My A4LD The second!
ok When the Transmission is cold. It doesn't Like to go into gear(all gears). It just sits there sometimes. Bringing the rpm up slightly will after a few seconds cause the tranny to go into gear. You can hear what sounds like to me a hydraulic...
I am looking to replace my front springs in a short while as they are sagging and screwing up my alignment and eating tires.
Last year I put the cheap washer spacers under my springs for some lift. this wasn't to gain actual lift but to attempt to bring the springs somewhere near original ride...
Howdy peps. After waiting a year to fix the A/C on my truck, today I looked into the problem.
I found a hole in the front rad. what ever its called. replaced it from my parts truck. vacuumed out the system and put in new gas.
but the clutch does not engage on the pump. I jumped the low...
Is it possible to take the tail end of a A4ld 4x4 transmission and put it on a M5OD 2wd transmission and turn the 2wd M5od into a something the transfer case will bolt too and have the correct driveshaft length?
I have a dead A4LD 4x4 tranny and for the life of me I cannot find a 4x4 M5od...
A friend of mine rolled his 1998 ranger this winter and It was written off by the insurance company.
In any case I am getting some free parts.
One of the parts is a Tonneau cover. Its old and sun dried, The edge on one side is starting to tear. While I did manage to get it on to my...
Well I have finally located a replacement bed for my 92 xlt 6 foot bed. Its sitting on a 94 in a junk yard.
Its the right length. so it should just bolt right on.
What about the rear lights? Will mine line up and screw on to the newer bed? Or am I going to have to shell out more cash...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.