Search results

http://bigrubbers4x4.org/forum/eventflyer/fallcrawl2014.jpg

https://www.facebook.com/events/600587763367103/

Last event of the year:

Sept 7th and 8th will be our 4th annual Roastin on the Rocks. see flyer below. any other question just ask.

http://bigrubbers4x4.org/forum/eventflyer/springthaw2013.jpg PM me for more info, vendor space still available

How many o-rings are supposed to be on the end of the speedo cable where it goes into the speed sensor? Mine keeps leaking there. pics would be helpful if more than one, which is what I have there now.

Sept 7-8-9 http://bigrubbers4x4.org/forum/showthread.php?3486-Roastin-on-the-Rocks-2012&p=35559#post35559

http://bigrubbers4x4.org/forum/showthread.php?3295-Spring-Thaw-May-19th-and-20th-2012 PM me for more info...

http://www.bigrubbers4x4.org/? PM me for more info...

the speedo cable came apart on my '89 B2 at the transfer case. It seem as though something is missing when I try to put it back together. the cable can't engage the gear now...It has a speed sensor before the transfer case as shown in the attached pic. Any help?

I'm swapping in a '96 explorer rear with disc brake. I connected the brakes like the original 7.5 rear. I swapped in a D30 in the front and connected the lines similiar to stock and used Wrangler extended brake lines. I cant get them to hold pressure even after replacing the master cyl. Any...

In process of doing a D30 swap on a '89 Bronco II. My question is to all that have done it before. What lift coil springs did you use? XJ coils? F150 coils? Also, What did you do to make the steering work? My D30 came from a 80's cherokee. thanks, Jason

I'm in process of swapping a D30 in my '89 Bronco II. Any recommendations on lift springs? I have access to 6" lift Cherokee springs so was going to try those.

After a wheeling trip over weekend I broke an axle shaft(passenger side). I also took on some water in the diff and i think it came in from the driver's side shaft. As far as I can tell, all there is a rubber seal there, it's prolly worn out as I have 220,000 miles. Is this replaceable? or is...

Last nite my keyswitch went bad at a gas station, the truck is still there. I can't insert the key. How do I go about removing/replacing the lock cylinder? I already removed the steering column plastic. BTW its a '92 ranger ext cab.... thanks!

i've read all about using coil spacers on Ranger to gain 1.5-2" of lift. Has anyone done this on a Bronco II? If so what did you do to lift the back? Any negative handling side effects? my '89 has good coils up front and i think ford spacers are the way to go... maybe explorer leafs in the rear...

When I got my bronco II last october, the fuel gauge didn't work. Recently I disconnected the battery for a while to weld some stuff. After reconnecting the battery and filling the tank as usual, the gauge is now reading half tank. Still not right, but it moved. Do you think the sending unit...