Search results

I'd love to see this too. Could you all also explain everything on how you set up the hydraulic clutch? Did you use the stock hoses, master cylinder, and fittings etc..

It's a coarse SAE pattern. I don't know the measurements but you can go to the hardware store and find a bolt that will thread in very easily.

Okay thanks. I’ll try that if I can’t figure anything else out.

It could be that because part of the exhaust was welded back in after I replaced the clutch a few weeks ago but this noise is very loud and definitely not a sound that a car should be making

I don’t think it’s that because the A/C is never used. The previous owner went and put hose clamps on all the A/C hoses so there is no Freon left in the system.

I've tried that to see if I could see any electrical connections sparking and there was nothing.

Hello, my truck is an 88 2.9 5 speed and it started making a very weird snapping sound from the back of the engine bay about two weeks ago. After about 5 miles of driving the sound starts but goes away after a few minutes and two weeks ago it was pretty quiet but over time it's gotten louder...

Okay thanks you all, I probably shouldn’t mess with it

Hello I just changed my transmission and clutch and I am trying to sell the old transmission and some parts I didn't use. The transmission makes quite a bit of noise and doesn't shift very smooth but I daily drove with it for 6 months. Someone could use it as a rebuildable core or a very budget...

Hello, I have a little plaque under my hood that says my vehicle is equipped with a fuel pump shut off switch and I can check the owner's manual to see where it is. I do not have the owners manual and I haven't been able to find the switch. Could someone tell me where the switch is? The truck...

I believe Mahle is mostly known for their pistons but their gaskets seem to be great too.

DO NOT buy the Duralast clutch slave cylinder. I got it because it's the only one available at parts stores around me. The bleeder valve and hose fittings weren't even long enough to be accessible from the outside of the bell housing. With that said the Mahle rear main seal is a huge upgrade...

They aren't even the same manufacturer so short answer is no

I appears to be working. The engine idles normally until I drive it for a few minutes then let it idle again.

I just removed the IAC and it was perfectly clean to start with. Now what?

Hello, My 1988 2.9 L engine is surging at idle and I'm wondering what could be causing it? After driving a short distance and coming to a stop, the engine will start to bounce between 400 and 1000 rpms until I turn the engine off. When I start the truck back up it idles fine until I drive for...

You might be able to view them on your vehicle on Tire Rack. I don't think they have that feature available for older trucks but its worth checking. They're very common wheels for a good reason so you should be able to find pics of them on similar trucks.

15s are considered the period correct size wheels for just about all pickup trucks before ~2000. There is no big mechanical advantage to 15s. Most people just like having more sidewall on the tire, and more sidewall will be better off road (the 1" doesn't really matter for off road performance...

That's in incredible condition for the year. If it were my truck I would sell those wheels and tires and get some more period correct and 15" wheels. Keep us updated!

It’s a white gear. I must have counted wrong.