I'm using a 00 v-8 explorer donor and going into a 00 4.oL ranger and wanted to see if anyone knows if the main housing is the same? Long story short can I take the disk brakes off of the explorer and put them on the ranger diff? If so Do I need to run the explorer axles?
I also have a wiring...
I've been searching the postings and I can't seem to find out how to adapt the 6 pin connector on the explorer engine harness to the rangers body harness located roughly underneath master cylinder. I'm using the engine harness, computer and pats system from explorer.
Any ideas? It sounds like...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.