Search results

I have a 99 Supercab 4X4 and just installed a winch on the Affordable Off Road front bumper. That winch is an older Ramsey unit and it pulls a lot of amperage in use. I have only would the synthetic rope on it and the battery gauge indicated it took a lot of power to do that (the winch had sat...

I just bought this truck and think I should get a scanner in case or problems in the backcountry. I don't need a 410k Snap-on, don't want a cheap, Amazon, Chinese special either. Any suggestions from those who know?

I have been working on this Southern Nevada truck, but have not gotten much past the suspension upgrades. I installed NEW: Skyjacker rear 4" lift springs with extended shackles, Skyjacker front TTB pivot brackets, and James Duff radius arms. It came with front 4" lift springs, but I don't know...

I inherited a supposedly 93' 4.0 Liter engine with a 90 Ranger and was working to install the clutch. I cleaned up the rear engine plate to find it says clearly AUTO on it when this is a manual setup. I had also noticed NO pilot bearing, so obviously the engine came from an automatic proabably...

I have been looking for a 5 speed manual trans for my project 90 Supercab Ranger and may have found an FM-146 with a transfer case. My project came with a 93 4.0L engine and M5OD-R1 2WD trans, which is not much use. How reliable is the Fm-146 in a 4WD application with a stock 4.0L engine, 4.56...

I have been looking for a 5 speed manual trans for my project 90 Supercab Ranger and may have found an FM-146 with a transfer case. My project came with a 93 4.0L engine and M5OD-R1 2WD trans, which is not much use. How reliable is the Fm-146 in a 4WD application with a stock 4.0L engine, 4.56...

I have a 93' 4.0L V-6 that has a 2WD trans on it and I need a 4WD transmission. Will a 95 3.0L V-6 manual trans bolt up to the engine I have? If not I can get a 4.0L trans from the local U Pick wrecking yard. Thanks for the help. I have a 90' Supercab I am putting this all into.

Hello all. New user here. I just bought a 90 SC Ranger 4X4 with a 93 4.0 and a 2wd M50 trans. I need to get a transfer case and the corect trans. Does anyone know if the spline count and size is the same between the auto and manual transmission output shafts to allow me to use a transfer...