A sd 33t Nissan diesel i have one that i am thinking of putting in my ranger. thay came in cj-10a's and scouts in the late 70's and till 85 ish in a N/A. the one i have is a turbo one from a Nissan forklift. they use a TF-727 in the cj and the scout had a t19 trans. i am thinking of putting...
Monster jam is the 30 sat night and it is one of the biggest event around. I by my tickets a year ahead of time every year because if you don't you in upper bowl lower bowl sells out usually the next few days.
Monster Eve returns this January 29th to the Jesse Black Saloon in Orlando (not sheer...
I am thinking of getting a 92 3500 srw truck for a parts truck to put the motor in the ranger it a a manual with 105000 ish on it. my question is how heavy is it and is there a good auto trans that i can put with it. my other options are a 7.3 that will need a lot more work it need a turbo...
I have a set of fiberwerks glass. I was thinking of what to do to fill the gap between the wheel well the the door to keep the door hinges from filling with dirt or mud.
we got a 6x6 crane truck in work to day that i can get the axles out of for the price we can sell the melt for just a lot of cutting and such. I think they are 5 ton top loader in the rear and a front loader up front. don't think i would have a use for them but I'm in FL so i think i cant find...
any one seen some that makes a 8x6.5 to 8x170 1.5in adapters.
I wound like to run the 14blot rear i have but it is 3in narwer and 8x6.5 and my front is 8x170.
i have had this truck for some time started was going to be a prerunner then going the have a d44 9" but got a 60 this week. i have put off the build for all most a year for I'm building a house but i will be done the 24 so i what to get back to the ranger the guys at work what to go to Moab...
i have a newer 60 for a 03 f350 drw that i will be having cut down and putting new hubs on for srw. Has any one changes a ball joint to a king pin set up was thinking of changing it?
has any of you used EB coil perches on the ranger frame? How did you get past the weirdness of the drivers side frame rail. Fingering out how to do the spring is the only thing stopping me from proceeding on with the front end.
What spray/paint on bed liners have you used and do you still like it?
I will be going over sheet metal and fiber glass.
I will do the bed and if i like the finish i am thinking of doing the hole bottom 1/2 of the truck from door handle down and i have prerunner finders.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.